Safety Instructions - Power Adhesives 305-12 Manual Instrucciones De Uso

EN

SAFETY INSTRUCTIONS

Do not touch the nozzle or molten
adhesive with bare skin as they are
hot - the operating temperature of
this tool is approximately 200°C /
392°F (LT 120°C / 248°F). Protective
gloves should always be worn.
Careless handling can cause skin
burns. If molten adhesive comes into
contact with the skin, immerse the
affected area immediately in plenty
of cold water. Seek medical advice
if necessary. In addition to the safety
instructions herein, any statutory
regulations, local fire insurance
regulations, or other generally valid
"regulations for accident prevention"
must be complied with when using
this tool.
Repairs should only be undertaken
by competent personnel with the
adequate electrical knowledge. Before
proceeding with any maintenance or
repair operation, disconnect the tool
from the mains electricity supply. If in
doubt, contact your supplier.
• WARNING - This tool must be
placed on its stand when not in use;
do not leave the tool unattended
when switched ON.
• Place the tool on its stand after
use and allow it to cool down before
storage.
• Never use the tool if it is damaged
in any way. If the supply cord is
damaged, it must be replaced by the
manufacturer, its service agent or
similar qualified persons in order to
avoid a hazard.
• Do not use this tool whilst under the
influence of drugs or alcohol.
• Do not use this tool in damp rooms,
and do not expose to rain, moisture
or immerse in water.
• Do not use this tool in the vicinity
of any heat-sensitive materials, or
any flammable materials, liquids, or
gases, and do not apply to the same
place for a long time.
• Only use extension cables with a
wire cross-section of 1.5mm² / 16
a.w.g. and no more than 20m / 65 ft
in length.
• Depending on the country, this tool
may be fitted with a polarized plug,
intended to be fitted into a polarized
socket. If the plug does not fit fully
in the outlet, reverse the plug. If it
still does not fit please contact the
manufacturer. Do not modify the
tool's plug. Never pull on the tool's
connecting cable.
• This tool is not intended for the use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience