Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
NOzzLE CLEANING (FIG. 12)
If the nozzle becomes clogged with foreign materials, such as dirt, excessive
pressure may develop. If the nozzle becomes partially clogged or restricted, the
pump pressure will pulsate. Clean the nozzle immediately using the nozzle kit
supplied and the following instructions:
1.
Shut off the pressure washer and turn off the water supply.
2.
Pull trigger on gun handle to relieve any water pressure.
3.
Disconnect the spray wand from the gun.
4.
Remove the high-pressure nozzle (K) from the spray wand.
Remove any obstructions with the nozzle cleaning tool
provided and backflush with clean water.
5.
Direct water supply (N) into spray wand to backflush
loosened particles for 30 seconds.
6.
Reassemble the nozzle to the wand.
7.
Reconnect spray wand to gun and turn on water supply.
8.
Start pressure washer and place spray wand into high
pressure setting to test.
CLEAN THE WATER INLET FILTER (FIG. 8)
This screen filter should be checked periodically and cleaned if necessary.
1.
Remove filter by grasping end and removing it from water inlet of pump.
2.
Clean filter by flushing it with water on both sides.
Re-insert filter into water inlet of pump. NOTE: Cone side faces out.
3.
NOTE: Do not operate the pressure washer without filter properly installed.
ENGINE
Consult the Engine Owners Manual for manufacturer's recommendations for
storage.
PumP (FIG. 13)
NOTIcE: The manufacturer recommends using a pump protector/winterizer when
storing the unit for more than 30 days and/or when freezing temperatures are
expected. fREEZE DAMAGE Is NOT cOVERED by ThE WARRANTy.
Pump protector/winterizer is usually available at the store where the pressure
washer was purchased. If a pump protector/winterizer is not available, RV
antifreeze needs to be run through the pump as outlined in the steps below.
NOTE: Using a pump protector/winterizer or RV antifreeze is to provide proper
lubrication to the internal seals of the pump regardless of temperature or
environment.
1.
Obtain a funnel, 6 ounces (170 mL) of RV
Antifreeze, and a 16" to 36" (40-91 cm)
section of garden hose with a male hose
connector attached to one end.
NOTIcE: Risk of Property Damage. Use only RV
Antifreeze. Any other antifreeze is corrosive and
can damage the pump.
2.
Disconnect the spark plug wire.
STORAGE
17 - ENG
12
N
13
k
k
Publicidad
Tabla de contenido
