Pressure Washer Terminology - Simpson S2700H Manual De Instrucciones

G. Handle
H. Frame
I. Pump Outlet
J. Pump Inlet
K. Quick Connect Nozzles
BASIC ELEMENTS OF AN ENGINE
Refer to the engine manual for location and operation of engine controls.
1. Locate and remove all loose parts from the carton.
2. Cut four corners of the carton from top to bottom and lay the panels flat.
3. Place handle (G) onto frame (H) and secure with saddle bolt (R) and knob (L).
G
H
CAUTION: Risk of personal injury. Avoid placing hands between handle
and frame when assembling to prevent pinching.
4. Remove the colored quick-connect nozzles (K)
from the plastic bag and insert them into correct
grommet on the nozzle holder. Nozzles are color
coded to match colored nozzles on label (Q).
5. Connect wand (E) to gun (D). Tighten securely.
6. Attach high pressure hose (C) to gun (D). Tighten
se cure ly.
3
NOTE: The pump on this unit is maintenance free and requires no oil. If there
is a problem with the pump, contact our Customer Service Group on www.
simpsoncleaning.com as soon as possible.
NOTICE: The engine is shipped without oil. Before starting engine, add the oil pro-
vided. Damage to the engine will occur if the engine is ran without oil, this damage
will not be covered under warranty.

PRESSURE WASHER TERMINOLOGY

PSI: Pounds per Square Inch. The unit of measure for water pressure. Also used
for air pressure, hydraulic pressure, etc. Sometimes noted as "Bar", another unit
of measure.
ASSEMBLY INSTRUCTIONS (FIG. 1– 4)
R
L
E D
OPERATION
2
4
11 - ENG
K
D
C
Q