Simpson MegaShot MSH3125 Manual De Instrucciones página 11

G. handle
h. frame
I. Pump Outlet
j. Pump Inlet
k. quick Connect Nozzles
L. Nozzle holder
BASIC ELEMENTS OF AN ENGINE
Refer to the engine manual for location and operation of engine controls.
Choke Control: Opens and closes carburetor choke valve.
Starter Grip: Pulling starter grip operates recoil starter to crank engine.
Engine Switch: Enables and disables ignition system.
1. Locate and remove all loose parts from the carton.
2. Cut four corners of the carton from top to bottom and lay the panels flat.
3. Place handle (G) onto frame (H), depress the snap buttons, and slide the
handle assembly onto the frame until snap buttons snap into place.
NOTIcE: Risk of personal injury. Avoid placing hands between handle and frame
when assembling to prevent pinching.
4. Place the nozzle holder (L) onto the panel (located on the handle assembly)
and push each nozzle holder into place.
5. Remove colored quick connect nozzles (K) from plastic bag and insert them
into correct grommet on the nozzle holder. NOTE: Nozzles are color coded to
match colored nozzles on panel.
2
G
h
6. Connect wand (E) to gun (D). Tighten securely.
7. Attach high pressure hose (C) to gun (D). Tighten se cure ly.
3
NOTE: The pump on this unit is maintenance free and requires no oil. If
there is a problem with the pump, contact our Customer Service Group on
www.simpsoncleaning.com as soon as possible.
NOTIcE: The engine is shipped without oil. Before starting engine, add the oil
provided. Damage to the engine will occur if the engine is ran without oil, this
damage will not be covered under warranty.
ASSEMBLY INSTRUCTIONS (FIG. 1– 4)
2A
E
L
D
11 - ENG
k
L
4
D
C