Features; Assembly - Surtek DG725 Manual De Usuario

• Engines can become extremely hot during
normal operation.
To prevent fire hazard: Keep the engine at
least 1 m (3.3 ft) away from buildings, obstruc-
tions and other flammable objects.
DO NOT place flammable objects close to the
engine.
DO NOT expose combustible materials to the
engine exhaust.
To avoid getting an electric shock, DO NOT
touch spark plugs, plug caps or spark plug
leads during engine running.
To avoid a serious burn, DO NOT touch a hot
engine or muffler. The engine becomes hot
during operation. Before you service or remove
parts, stop engine and allow the engine to
cool.
SPECIFIC SAFETY RULES FOR GAS TRIMMERS
• DO NOT place hands or feet near moving or
rotating parts. Place a protective cover over
pulley, V belt or coupling.
• DO NOT run engine at excessive speeds. This
may result in injury.
• Replace string head if cracked, chipped, or
damaged in any way. Be sure the string head is
properly installed and securely fastened. Fail-
ure to do so can cause serious injury.
• Make sure all guards, straps, deflectors and
handles are properly and securely attached.
• Use only the manufacturer's replacement
string in the cutting head. Do not use any oth-
er cutting attachment.
• Never operate unit without the grass deflec-
tor in place and in good condition.
• Maintain a firm grip on both handles while
trimming. Keep string head below waist level.
Never cut with the string head located over 76
cm (30 in.) or more above the ground.
• The cutting attachment should stop turning
when the engine idles because it is equipped
with a clutch. If the cutting attachment con-
tinues to turn when the engine idles, contact a
service dealer for repair.
E N G L I S H •

FEATURES

KNOW YOUR TOOL
1. HOUSING.
2. STARTER HANDLE.
3. FUEL TANK.
4. "D" HANDLE.
5. ON/OFF SWITCH.
6. THROTTLE TRIGGER.
7. SAFETY TRIGGER.
8. LOCK KNOB.
9. DRIVE SHAFT.
10. DEBRIS SHIELD.
11. STRINGHEAD.
12. CUTTER LINE.

ASSEMBLY

FRONT HANDLE "D"
1. To install handle
onto unit, you will
need the following
components from
your user kit: handle
(A & B), screws and
nuts (Fig. 1).
2. Install the handle on the shaft at 160-200mm
from throttle and tighten the 2 screws and
nuts.
GRASS DEFLECTOR
WARNING: The guard must be installed to
properly dispense trimming line and protect
operator. Deflector fits snug on shaft. Some ef-
fort may be required.
1. Seat shield (B) onto shaft bracket (C).
U se r ' s m an ua l
1
2
7
3
5
6
4
9
10
12
11
A
B
Fig. 1
11