Maintenance; Specifications; Tuner Section; Wireless Communication - Sony XSP-N1BT Manual De Instrucciones

Ocultar thumbs Ver también para XSP-N1BT:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Maintenance

Replacing the lithium battery of the remote
commander
When the battery becomes weak, the range of the
remote commander becomes shorter. Replace the
battery with a new CR2025 lithium battery. Use of
any other battery may present a risk of fire or
explosion.
Notes on the lithium battery
 Keep the lithium battery out of the reach of children.
Should the battery be swallowed, immediately
consult a doctor.
 Wipe the battery with a dry cloth to assure a good
contact.
 Be sure to observe the correct polarity when installing
the battery.
 Do not hold the battery with metallic tweezers,
otherwise a short-circuit may occur.
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble, or dispose of in
fire.
Cleaning the magnetic charging connectors
The unit may not function properly if the magnetic
charging connectors between the unit and the
smartphone are not clean. In order to prevent this,
clean the magnetic charging connectors with a
cotton swab. Do not apply too much force.
Otherwise, the magnetic charging connectors may
be damaged.
Notes
 For safety, turn off the ignition before cleaning the
magnetic charging connector, and remove the key
from the ignition switch.
 Never touch the magnetic charging connectors
directly with your fingers or with any metal device.

Specifications

Tuner section

FM
Tuning range:
FM tuning step:
+ side up
Antenna (aerial) terminal:
Intermediate frequency: 25 kHz
Usable sensitivity: 8 dBf
Selectivity: 75 dB at 400 kHz
Signal-to-noise ratio: 80 dB (stereo)
Separation: 50 dB at 1 kHz
Frequency response: 20 – 15,000 Hz
AM
Tuning range:
AM tuning step:
Antenna (aerial) terminal:
Intermediate frequency:
Sensitivity: 26 μV
CD Player section
Signal-to-noise ratio: 120 dB
Frequency response: 10 – 20,000 Hz
Wow and flutter: Below measurable limit
Corresponding codec: MP3 (.mp3) and WMA (.wma)
USB Player section
Interface: USB (High-speed)
Maximum current: 1 A
The maximum number of recognizable tracks:
Corresponding codec:

Wireless Communication

Communication System:
Output:
Maximum communication range:
Frequency band:
87.5 – 108.0 MHz (at 50 kHz step)
87.5 – 108.0 MHz (at 100 kHz step)
87.5 – 107.9 MHz (at 200 kHz step)
50 kHz/100 kHz/200 kHz switchable
External antenna (aerial) connector
531 – 1,602 kHz (at 9 kHz step)
530 – 1,710 kHz (at 10 kHz step)
9 kHz/10 kHz switchable
External antenna (aerial) connector
9,124.5 kHz or 9,115.5 kHz/4.5 kHz (at 9 kHz step)
9,115 kHz or 9,125 kHz/5 kHz (at 10 kHz step)
1.5 A (When [CHARGE] is set
to [CHARGE HIGH])
10,000
MP3 (.mp3), WMA (.wma) and WAV (.wav)
BLUETOOTH Standard version 3.0
BLUETOOTH Standard Power Class 2
(Max. +4 dBm)
Line of sight approx. 10 m (33 ft)*
2.4 GHz band (2.4000 – 2.4835 GHz)
1
21
GB

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido