Troubleshooting; Radio Reception - Sony XSP-N1BT Manual De Instrucciones

Troubleshooting

The following checklist will help you remedy
problems you may encounter with your unit.
Before going through the checklist below, check
the connection and operating procedures.
For details on using the fuse and removing the unit
from the dashboard, refer to the installation/
connections manual supplied with this unit.
If the problem is not solved, visit the support site on
the back page.
General
No power is being supplied to the unit.
 If the unit is turned off and the display
disappears, the unit cannot be operated with the
remote commander.
 Turn on the unit.
No sound.
 The position of the fader control [FADER] is not
set for a 2-speaker system.
No beep sound.
 An optional power amplifier is connected and
you are not using the built-in amplifier.
The contents of the memory have been erased.
 The power supply lead or battery has been
disconnected or not connected properly.
Stored stations and correct time are erased.
The fuse has blown.
Makes a noise when the position of the ignition
is switched.
 The leads are not matched correctly with the car's
accessory power connector.
During playback or reception, the demonstration
mode starts.
 If no operation is performed for 5 minutes with
[DEMO-ON] set, the demonstration mode starts.
 Set [DEMO-OFF] (page 18).
The display disappears from/does not appear in
the display window.
 The dimmer is set to [DIM-ON] (page 18).
 The display disappears if you press and hold OFF
for 2 seconds.
 Press SOURCE until the display appears.
The display disappears while the unit is
operating.
 The Black Out function is set to on (page 18).
The operation buttons do not function.
The disc will not eject.
 Press SRC and VOLUME – on the main unit for
more than 2 seconds to reset the unit.
The contents stored in memory are erased.
For your safety, do not reset the unit while you
are driving.
The smartphone connected via a USB cable does
not charge.
 Make sure that the cable is connected correctly.
 Set [CHARGE] to [CHARGE STD] (page 16).

Radio reception

Stations cannot be received.
The sound is hampered by noises.
 The connection is not correct.
 If your car has built-in radio antenna (aerial) in
the rear/side glass, connect an REM OUT lead
(blue/white striped) or accessory power supply
lead (red) to the power supply lead of a car's
antenna (aerial) booster.
 Check the connection of the car antenna
(aerial).
 If the auto antenna (aerial) will not extend,
check the connection of the power antenna
(aerial) control lead.
 The tuning step setting has been erased.
 Set the tuning step again (page 7).
Preset tuning is not possible.
 The broadcast signal is too weak.
RDS
PTY displays [- - - - - - - -].
 The current station is not an RDS station.
 RDS data has not been received.
 The station does not specify the program type.
CD playback
The disc does not play back.
 Defective or dirty disc.
 The CD-R/CD-RW is not for audio use (page 19).
MP3/WMA files cannot be played back.
 The disc is incompatible with the MP3/WMA
format and version. For details on playable discs
and formats, visit the support site.
MP3/WMA files take longer to play back than
others.
 The following discs take a longer time to start
playback.
 A disc recorded with a complicated tree
structure.
 A disc recorded in Multi Session.
 A disc to which data can be added.
23
GB