Messages - Sony DSX-A110U Manual De Instrucciones

* This unit supports FAT16 and FAT32, but some USB
device may not support all of these FAT. For details,
refer to the operating instruction of each USB device
or contact the manufacturer.
Operations for skipping an album, skipping
items (Jump mode), and searching a track by
name (Quick-BrowZer) cannot be performed.
 These operations cannot be performed when a
USB device in Android mode is connected.
 Set [USB MODE] to [MSC/MTP] (page 11).
 The USB mode of the device is not set to the
appropriate mode.
 Make sure that the USB mode of the device is
set to MSC/MTP mode.
The sound cannot be output during playback in
Android mode.
 While the unit is in Android mode, the sound
outputs only from the Android smartphone.
 Check the status of the audio playback
application on the Android smartphone.
 Playback may not perform properly depending
on the Android smartphone.

Messages

The following messages may appear or flash during
operation.
HUB NO SUPRT: USB hubs are not supported.
INVALID
 The selected operation could be invalid.
NOT SUPPORT - ANDROID MODE
 A USB device not supporting AOA (Android Open
Accessory) 2.0 is connected to the unit while [USB
MODE] is set to [ANDROID].
 Set [USB MODE] to [MSC/MTP] (page 11).
OVERLOAD: The USB device is overloaded.
 Disconnect the USB device, then press SRC to
select another source.
 The USB device has a fault, or an unsupported
device is connected.
READ: Now reading information.
 Wait until reading is complete and playback
starts automatically. This may take some time
depending on the file organization.
USB ERROR: The USB device cannot be played.
 Connect the USB device again.
USB NO DEV: A USB device is not connected or
recognized.
 Make sure the USB device or USB cable is securely
connected.
USB NO MUSIC: There is no playable file.
 Connect a USB device containing playable files
(page 14).
USB NO SUPRT: The USB device is not supported.
 For details on the compatibility of your USB
device, visit the support site on the back cover.
For steering wheel remote control
operation:
ERROR: An error occurred during the function
registration.
 Register again from the function where the error
occurred (page 11).
TIMEOUT: The function registration failed due to a
timeout.
 Try completing the registration while [REGISTER]
is blinking (about 6 seconds) (page 11).
For firmware update operation:
FILE ERROR: The updater is not stored in the USB
device.
 Store the updater in the USB device, then try
again (page 13).
17
GB