Dyson DC52 Manual De Instrucciones página 32

Looking for blockages. Vérification de l'absence d'obstructions. Blockierungen entfernen. Controleren op verstoppingen. Eliminación de obstrucciones.
Ricerca delle ostruzioni. Поиск засоров. Iskanje blokad.
Looking for blockages. Vérification de l'absence d'obstructions. Blockierungen entfernen. Controleren op verstoppingen. Eliminación de obstrucciones.
Ricerca delle ostruzioni. Поиск засоров. Iskanje blokad.
x2
EN
USING YOUR DYSON APPLIANCE
PLEASE READ THE 'IMPORTANT SAFETY INSTRUCTIONS' IN THIS DYSON
OPERATING MANUAL BEFORE PROCEEDING.
CARRYING THE APPLIANCE
• Carry the appliance by the main handle on the body.
• Do not press the cyclone release button or shake the appliance when carrying or
the cyclone could disengage, fall off and cause injury.
OPERATION
• Always extend the cable fully to the red tape before use.
• Plug the appliance into the mains electricity supply.
• To switch 'ON' or 'OFF' press the red power button, located as shown.
• After use: unplug, retract the cable safely, put the appliance away.
• Switch 'OFF' the appliance, unplug and ensure it is upright before:
– changing or using tools
– removing the hose or airway inspection parts.
DUAL MODE FLOOR TOOL WITH
SUCTION CONTROL
• Your appliance has a Dual mode floor tool with suction control. This cleaner
head is used for testing with the European Regulations: No. 665/2013 and
No. 666/2013.
POWERFUL SUCTION
• For vacuuming of lightly soiled carpets, rugs and hard flooring.
– Your appliance is pre-set to this level of suction when you take it out of the
box.
MAXIMUM SUCTION
• For vacuuming durable floor coverings, hard floors and heavily soiled carpets
and rugs.
– To switch to this setting, move the suction control slider on top of the cleaner
head as shown.
– CAUTION: The suction of this mode can damage delicate flooring. Before
vacuuming, check the flooring manufacturer's cleaning recommendations.
– If the suction power of Maximum suction prevents easy manoeuverability,
switch to Powerful suction mode.
– To switch back to Powerful suction mode, move the suction control slider back
to its original position, as shown.
32
LOOKING AFTER YOUR DYSON APPLIANCE
• Do not carry out any maintenance or repair work other than that shown in this
Dyson Operating Manual, or advised by the Dyson Helpline.
• Only use parts recommended by Dyson. If you do not this could invalidate
your guarantee.
• Store the appliance indoors. Do not use or store it below 3°C (37.4°F). Ensure
the appliance is at room temperature before operating.
• Clean the appliance only with a dry cloth. Do not use any lubricants, cleaning
agents, polishes or air fresheners on any part of the appliance.
• If used in a garage, always wipe the base plate and ball with a dry cloth
after vacuuming to clean off any sand, dirt, or pebbles that could damage
delicate floors.
VACUUMING
• Do not use without the clear bin and cyclone in place.
• Do not use on rubble, ash or plaster. This appliance is designed only for
domestic use to remove household dirt, hair and allergens. The appliance is not
designed to be used on:
– debris produced from activities such as DIY, building or similar tasks
– larger types and quantities of dust or debris, such as soot and sawdust.
These materials may harm the appliance and may void your guarantee.
• Fine dirt such as flour should only be vacuumed in very small amounts.
• Do not use the appliance to pick up sharp hard objects, small toys, pins, paper
clips, etc. They may damage the appliance.
• When vacuuming, certain carpets may generate small static charges in the
clear bin or wand. These are harmless and are not associated with the mains
electricity supply. To minimize any effect from this (small static charge), do
not put your hand or insert any object into the clear bin unless you have first
emptied it and cleaned it with a damp cloth (see 'Cleaning the clear bin').
• Do not work with the appliance above you on the stairs.
• Do not put the appliance on chairs, tables, etc.
• Before vacuuming highly polished floors, such as wood or lino, first check that
the underside of the floor tool and its brushes are free from foreign objects that
could cause marking.
• Do not push hard with the floor tool when vacuuming, as this may
cause damage.
• Do not leave the cleaner head in one place on delicate floors.
• On waxed floors the movement of the cleaner head may create an uneven
lustre. If this happens, wipe with a damp cloth, polish the area with wax, and
wait for it to dry.
• To reduce suction (for example, when vacuuming rugs), pull the suction release
trigger on the handle to reduce the airflow.
x2