Adjusting Depth Of Cut - Makita XSR01 Manual De Instrucciones

Sierra inalámbrica de empuñadura posterior
Ocultar thumbs Ver también para XSR01:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Indicator lamps
Lighted
Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Automatic speed change function
This tool has "high speed mode" and "high torque
mode".
The tool automatically changes the operation mode
depending on the work load. When the the work load
is low, the tool will run in the "high speed mode" for
quicker cutting operation. When the the work load is
high, the tool will run in the "high torque mode" for pow-
erful cutting operation.
1
► 1. Mode indicator
The mode indicator lights up when the tool is running in
"high torque mode".
Mode indicator status
On
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
Operation mode
Off
High speed mode
High torque mode

Adjusting depth of cut

CAUTION:
After adjusting the depth of cut,
always tighten the lever securely.
Loosen the lever on the depth guide and move the base
up or down. At the desired depth of cut, secure the base
by tightening the lever.
For cleaner, safer cuts, set cut depth so that no more
than one blade tooth projects below workpiece. Using
proper cut depth helps to reduce potential for danger-
ous KICKBACKS which can cause personal injury.
1
► 1. Lever
Bevel cutting
Loosen the lever and set for the desired angle by tilting
accordingly, then tighten the lever securely.
1
► 1. Lever
Positive stopper
The positive stopper is useful for setting the des-
ignated angle quickly. Turn the positive stopper so
that the arrow on it points your desired bevel angle
(22.5°/45°/53°). Loosen the lever and then tilt the tool
base until it stops. The position where the tool base
stops is the angle you set with the positive stopper.
Tighten the lever with the tool base is at this position.
8 ENGLISH

Publicidad

Tabla de contenido
loading

Tabla de contenido