Window Requirements - GE AEN08 Serie Manual Del Propietario Y Instrucciones De Instalación

WINDOW REQUIREMENTS

1
These instructions are for a standard
double-hung window. You will need to modify
them for other types of windows.
CAUTION:
bolts do not contact the window sill, or
if you have a window without a sill, you
must order accessory kit RAK87 to
properly install this air conditioner.
Call 800.626.2002 or visit GEAppliances.com.
The air conditioner can be installed without
the accordion panels if needed to fit in a
narrow window. See the window opening
dimensions.
All supporting parts must be secured
to firm wood, masonry or metal.
The electrical outlet must be within reach of
the power cord.
(With accordion panels)
STORM WINDOW REQUIREMENTS
2
A storm window frame will not allow the air
conditioner to tilt toward the outside, and will keep
it from draining properly. To adjust for this, attach
a piece of wood to the sill.
WOOD PIECES –
WIDTH: 2
LENGTH: Long enough to fit inside the window
frame.
THICKNESS: To determine the thickness, place a
piece of wood on the sill to make it 1/2 higher
than the top of the storm window frame or the
vinyl frame.
Attach securely with nails or screws provided
by the installer.
1/2 higher
than storm
window
frame
Storm window
frame
Installation Instructions
If the sill support
14.5" min.
22.6 to 38.1
1/2 higher
than vinyl frame
(on some windows)
Wood
Sill
Vinyl frame
REMOVE THE AIR CONDITIONER
3
FROM THE CASE
A Remove and save the 2 screws from the lower
sides of the front grille.
Grasp the lower corners of the grille while
B
pressing in on the case sides with your finger
tips. Pull out to release and lift it up.
NOTE: Do not pull the bottom edge toward you
more than 3 or you may damage the tabs of
the grille.
When the front grille is removed the control
C
panel will still be attached by a harness. Turn
the grille around so you can see the back
side of the grille. Remove the three screws to
separate the control panel housing from the
grille.
Remove the ground screw from each side of
D
the case. Keep them in a safe location.
NOTE: Be sure to save these screws. You will
need them later in the installation.
9
FRONT
FRONT
remove screws
FRONT