Troubleshooting - Schneider Airsystems KTP 310 Manual De Instrucciones

GB
KTP/SIP
2.9

Troubleshooting

Observe the safety instructions and maintenance instructions!
Problem
A No material flow or
insufficient mate-
rial flow
B Air pockets during
silicone application
C Air escaping at
front union nut
*For troubleshooting: refer to the information in the "Technical data" chapter in part 1 of the instruction manual!
If necessary, contact our service staff, see last page.
II/ 8
Cause
Silicone tip clogged
Air regulation adjusted
incorrectly
Incorrect working pressure
Compressor output too small
Hose diameter too small
Cartridge bottom defective
Rear side seal for
cartridge sealing dirty
Remedy
Cleaning
Correct air
*
regulation
*
Make correction
Use different output
*
rating
Use correct hose
*
diameter
Replace cartridge
Clean / replace