Explanation Of Warning Symbols And Notes; Safety Instructions; Start-Up And Operation - Hama 00200016 Instrucciones De Uso

G Operating instruction

1. Explanation of warning symbols and notes

Risk of electric shock
This symbol indicates a risk of electric shock from
touching product parts carrying hazardous voltage.
Warning
This symbol is used to indicate safety instructions or to
draw your attention to specific hazards and risks.
Note
This symbol is used to indicate additional information or
important notes.
2. Package contents
• Universal USB-C notebook power supply unit
• USB-C 2.0 Cable 3 A (max. 60W)
• These operating instructions

3. Safety instructions

• Use the product only for the intended purpose.
• Do not use the product in the immediate vicinity of
heaters, other heat sources or in direct sunlight.
• Ensure there is sufficient scope for heat dissipation and
ventilation.
• Only use the article under moderate climatic conditions.
• Do not use the product in areas in which electronic
products are not permitted.
• Do not use the product in a damp environment and
avoid splashing water.
• Do not short-circuit the battery of the opened terminal
device. There is a risk of explosion.
• Protect the product from dirt, moisture and overheating
and use it in dry environments only.
• Do not drop the product and do not expose it to any
major shocks.
• Do not operate the product outside the power limits
specified in the technical data.
• Always pull directly on the plug when disconnecting the
cable, never on the cable itself.
• Make sure that cables do not pose a tripping hazard or
block emergency exits.
• Do not bend or crush the cable.
• As with all electrical products, this device should be kept
out of the reach of children.
• Do not modify the device in any way. Doing so voids the
warranty.
• Keep the packaging material out of the reach of children
due to the risk of suffocation.
• Dispose of packaging material immediately in
accordance with the locally applicable regulations.
2
Risk of electric shock
• Do not open the device or continue to operate it if it
becomes damaged.
• Do not use the product if the AC adapter, adapter
cable or power cable is damaged.
• Do not attempt to service or repair the product
yourself. Leave any and all service work to qualified
experts.

4. Start-up and operation

Note – mains voltage 100 – 240 V
The power supply unit is suitable for mains voltages
of 100 – 240 V and therefore can be used worldwide.
Please note that a country-specific adapter may be
necessary.
• Ensure that your notebook requires a supply voltage of
5 V / 9 V / 12 V / 15 V / 20 V (+/- 1 Volt).
• You can find this information on the original power
supply unit or in your terminal device's operating
manual. If necessary, ask the dealer who supplied
your terminal device or contact your terminal device
manufacturer's support service.
Warning
• Do not use the universal notebook power supply unit if
you are unable to definitively determine your terminal
device's supply voltage.
• Ensure that the total power consumption does not
exceed the power supply unit's rated output capacity
of 65 W.
• Failure to comply with this may cause damage to
the universal notebook power supply unit and the
connected terminal device!
Note the instructions in your device's operating manual.
If these do not contain any instructions expressly to the
contrary, proceed as follows:
Note – Power Delivery/Quick Charge
• Plug & GO: no additional software required, simply
plug in and start:
Thanks to Power Delivery/Thunderbolt™ 3/Quick
Charge, the voltage and power are adjusted
automatically.
• Be aware that, for efficient and optimised charging,
your terminal device must support the PD (Power
Delivery)/TBT3 (Thunderbolt™ 3)/QC (Quick Charge)
function.
• If you have a large number of PD/TBT3/QC-enabled
terminal devices with different firmware updates, it
may be that the function is not fully supported.