Metabo HPT C 10FSH C 10FSHS Instrucciones De Seguridad Y Manual De Instrucciones página 14

English
5. Confi rmation for use of sub fence
WARNING:
Left bevel angle cutting
Turn
Sub Fence
Fence (B)
Fig. 12
6. Oblique angle
Before the power tool is shipped from the factory, it is adjusted for 0°, right angle, left 45° bevel cutting angle
and right 45° bevel cutting angle with the 8mm bolt (A), 8mm bolt (B) and the 8mm bolt (C).
When changing the adjustment, change the height of the 8mm bolt (A), 8mm bolt (B) or the 8mm bolt (C) by
turning them.
When changing the bevel angle to the right 45°, pull the fi xing pin on the direction shown in Fig. 13-a and incline
the motor head to the right.
When adjusting the motor head to 0°, always return the fi xing pin to its initial position as shown in Fig. 13-b.
8mm Bolt (C)
(Stopper for left 45°
bevel angle)
7. Securing the workpiece
WARNING:
8. Installing the sub table
8 mm bolt
6 mm knob bolt
Steel square
Holder
Height adjustment
bolt 8 mm
Fig. 14
14
In the case of left bevel cutting, turn the sub fence counterclockwise. Unless it is
turned counterclockwise, the main body or saw blade may contact the sub fence,
resulting in an injury.
This power tool is Equipped with a sub fence.
Right bevel angle cutting
Direct angle cutting
In the case of direct angle cutting and right bevel angle cutting, use the
sub fence. Then, you can realize stable cutting of the material with a
wide back face.
In the case of left bevel cutting, raise the sub fence up as illustrated in
Fig. 12 and then turn it counterclockwise.
Fixing Pin
Pull
Indicator
(For left bevel
scale)
Fig. 13-a
Always clamp or vise to secure the workpiece to the fence; otherwise the workpiece
might be thrust from the table and cause bodily harm.
Using an item such as a steel square, match the upper surfaces of the
base surface and sub table. Adjust the vertical level of the sub table
by turning the 8 mm height adjustment bolt. After the adjustment,
secure the holder with the 8 mm bolt on the rear of the base, and
secure the 6 mm knob bolt of the sub table.
Always use the sub table during operation and fi x properly with 8 mm
bolt. (Fig. 14)
Base surface
Sub table
Indicator (For right bevel scale)
Return
Fixing Pin
Fig. 13-b
8mm Bolt (A) (Stopper for 0°)
8mm Bolt (B) (Stopper for right
45° bevel angle)