Metabo HPT C 10FSH C 10FSHS Instrucciones De Seguridad Y Manual De Instrucciones página 16

English
Laser line
Fig. 18
Workpiece
Marking
(pre-marked)
Fig. 19
Vise Assembly
Move
Laser Line
Fig. 20
Marking
(pre-marked)
Fig. 21
NOTE:
Check and make sure on a periodic basis if the position of the laser line is in order. As
regards the checking method, draw a right-angle ink line on the workpiece with the height
of about 25/32" (20mm) and the width of 5-29/32"(150mm), and check that the laser line is
in line with the ink line [The deviation between the ink line and the laser line should be less
than the ink line width (0.5mm)]. (Fig. 21)
16
Ink lining can be easily made on this tool to the laser marker. A switch
lights up the laser marker. (Fig. 18)
Switch
Depending upon your cutting choice, the laser line can be aligned with
the left side of the cutting width (saw blade) or the ink line on the right
side.
The laser line is adjusted to the width of the saw blade at the time of
factory shipment. Adjust the positions of the saw blade and the laser line
taking the following steps to suit the use of your choice.
Saw Blade (1) Light up the laser marker and make a groove of about 3/16" (5mm)
deep on the workpiece that is about 25/32" (20mm) in height and
5-29/32"(150mm) in width. Hold the grooved workpiece by vise as it
is and do not move it. For grooving work, refer to "11.Groove cutting
procedures" on page 24.
Cutting Width
(2) Then, turn the adjuster and shift the laser line. (If you turn the
adjuster clockwise, the laser line will shift to the right and if you turn it
counterclockwise, the laser line will shift to the left.) When you work
with the ink line aligned with the left side of the saw blade, align the
Turn
laser line with the left end of the groove. (Fig. 20) When you align it
with the right side of the saw blade, align the laser line with the right
side of the groove.
Groove Adjuster
(3) After adjusting the position of the laser line, draw a right-angle ink
line on the workpiece and align the ink line with the laser line. When
aligning the ink line, slide the workpiece little by little and secure it
by vise at a position where the laser line overlaps with the ink line.
Work on the grooving again and check the position of the laser line. If
you wish to change the laser line's position, make adjustments again
Laser Line
following the steps from (1) to (3).