ION TOTAL PA ULTRA Guia De Inicio Rapido página 6

16. Clip LED: This LED will flash red if the signal from the inputs or media panel source is clipping. If
this happens, decrease the setting of the Mic Input Volume knob, Aux Input Volume knob, or
Master Volume knob.
17. Power LED: Indicates whether Total PA Ultra is powered on or off.
18. Light Mode Button: Press this button to toggle between four modes for the lights on the front
panel:
•
Auto 1: The lights steadily cycle through different colors. As they cycle, the light ring will be
the same color as the glowing woofer. While operating in this mode, press and hold the
Light Mode button to freeze the lights on their current color. Press and hold again to
unfreeze. Auto 1 is the default mode when Total PA Ultra is powered on.
•
Auto 2: The lights steadily cycle through different colors. As they cycle, the light ring will be
a different color than the glowing woofer. While operating in this mode, press and hold the
Light Mode button to freeze the lights on their current color.
•
Beat Sync: The light ring flashes and changes colors according to the tempo of the music
playing on the speaker. The glowing woofer will steadily cycle through different colors.
•
Off: The lights turn off.
19. Power Cable Input (IEC): Insert the included power cable here to power the unit.
20. Fuse: The orientation of the fuse holder determines the current voltage setting
of Total PA Ultra. The current setting is shown above the white triangle ():
110–120 V or 220–240 V. If you use Total PA Ultra in a region with a different
voltage, change the voltage setting by removing the fuse holder, inverting it,
and reinserting it.
If the unit's fuse is broken, remove the fuse holder and replace the broken fuse
with one with the same rating (printed on the fuse holder). Using a fuse with an
incorrect rating can damage the unit and/or fuse.
21. Power Switch: Turns Total PA Ultra on or off.
Media Panel
Media Panel Functions:
MODE Mode: Switches modes from USB, SD, FM radio (if applicable), or Bluetooth.
Note: A USB drive or SD card must contain playable files in order for it to appear properly in
the media panel's display. You can play APE, FLAC, MP3, 16-bit WAV, and WMA files.
Play/Pause: Play/pause the USB, SD, or Bluetooth source. Press and hold Play/Pause for 2
seconds to begin the preset auto-store function (if applicable). This jumps to the lowest
station (87.5) and then travels through the bandwidth to auto-store the strongest stations as
presets.
Repeat: Repeat all of the tracks (ALL), repeat all of the tracks in the folder (FOLd), repeat the
current playing USB or SD track (OnE), or shuffle the track order (rAn).
Previous: Plays the previous USB, SD, or Bluetooth track. When listening to the FM radio (if
applicable), press the button once to skip back through the FM stations and hold the button
down to seek back through the channel presets.
Next: Plays the next USB, SD, or Bluetooth track. When listening to the FM radio (if
applicable), press the button once to tune the radio down one preset and hold the button
down to seek forward through the channel presets.
Note: In some apps, pressing the Previous (
music genre.
6
) or Next ( ) buttons may go to another playlist or