ION TOTAL PA ULTRA Guia De Inicio Rapido página 9

Troubleshooting
If the sound is distorted: Try lowering the volume control of your sound source or musical
instrument. Also, try to reduce the overall volume of Total PA Ultra.
If there is too much bass: Try adjusting the tone or EQ control from Total PA Ultra or your sound source
to lower the bass level. This will allow you to play the music louder before clipping (distortion) occurs.
If there is a high-pitched whistling noise when using a microphone: This is probably feedback.
Point the microphone away from the speaker.
If you can't hear the microphone over the music volume: Turn down the music volume from your
source.
When I press Previous (
presses of the button will jump to presets. Hold the button down to seek to the next station. (If
applicable)
If the radio station channel is flashing: The unit is currently muted. Unmute to stop the flashing
and resume playback.
The USB track number (Example: 001) is flashing slowly: The USB drive music playback is muted.
Unmute to stop the flashing and resume playback.
The LCD shows "NONE": The unit is in USB/SD mode, but there is no USB drive attached or no SD
card inserted. If a USB drive or SD card is already properly inserted, make sure it contains playable
files (APE, FLAC, MP3, 16-bit WAV, and WMA files).
If the Bluetooth logo is flashing rapidly: The unit is currently in pairing mode.
If the Bluetooth logo is flashing slowly: A device is paired, but the music is muted. Unmute to stop
the flashing and resume playback.
If you cannot connect your audio device to Total PA Ultra via Bluetooth:
•
Have your audio device (e.g., smartphone or tablet) and Total PA Ultra as close together as
possible while trying to connect. Make sure both the audio device and Total PA Ultra are
unobstructed by walls, furniture, etc.
•
Reset the Bluetooth connection on Total PA Ultra to disconnect Total PA Ultra from any other
audio device and restart the search process. If this does not work right away, power off Total
PA Ultra and then power it back on. See
•
Reset the Bluetooth connection on your audio device by turning Bluetooth off and back on. You
can find this under the Bluetooth menu in the Settings for your phone or other audio device.
If this does not work, and you have connected to Total PA Ultra before, find Total PA Ultra in the
list of available or previously connected devices in your audio device's Bluetooth menu, tap the
"gear" or "i" icon located next to it and then select Unpair or Forget. Turn Total PA Ultra off
and back on and try pairing again once it reappears in your available devices list.
Note: If Total PA Ultra has been paired to another audio device recently that is still within range,
you may need to repeat this process with that audio device to fully disconnect.
) or Next ( ), it doesn't increment to the next FM station: Short
Pairing a Bluetooth Device for more information.
9