CleanCraft HDR-K 90-20 Traducción De Las Instrucciones Originales página 20

3.1.16 W
EN Arning
the safety devices.
3.1.17 W
Arning
3.1.18 W
Arning
3.1.19 W
Arning
3.1.20 W
Arning
hose.
3.1.21 W
Arning
components, the high pressure jet is potentially dangerous. Do not use
the rotating nozzle kit, and always keep the jet at a distance of at least 30
cm during cleaning.
W
3.1.22
Arning
specifically intended for the model in question is prohibited. All modifica-
tions to the appliance are prohibited; any modifications shall render the
Declaration of Conformity null and void and relieve the manufacturer of
all liability under civil and criminal law.
3.2 SAFETY "MUSTS"
3.2.1 W
Arning
jet.
3.2.2 W
Arning
electrician and comply with IEC 60364-1. Either a residual current device
that will cut off the power supply if the leakage current to earth exceeds
30 mA for 30 ms or a ground fault interrupt device must be installed.
3.2.3 W
Arning
3.2.4 W
Arning
protection for the operator (30 mA).
W
3.2.5
Arning
staff.
3.2.6 W
Arning
conductor cross-section.
3.2.7 W
Arning
unattended.
20
. DO NOT tamper with or adjust the setting of the safety valve or
. DO NOT alter the original diameter of the spray head nozzle.
. DO NOT move the appliance by pulling on the ELECTRIC CABLE.
. DO NOT allow vehicles to drive over the high pressure hose.
. DO NOT move the appliance by pulling on the high pressure
. When directed towards tyres, tyre valves or other pressurised
. The use of non-original accessories and any other spare parts not
. All electrical conductors MUST BE PROTECTED against the water
. The electric supply connection must be made by a qualified
. DURING start-up, the appliance may cause network noise.
. Use of a residual current breaker (RCB) will provide additional
. Models supplied without plug must be installed by qualified
. Use only approved electrical extension leads with suitable
. Always turn off the switch when leaving the appliance