Saeco Armonia SIN024X Instrucciones Para El Uso página 24

ENGLISH
• Before using the machine, make sure that
the hot water/steam knob (7) is closed and
that there is a sufficient amount of water in
the tank.
• (Fig.4B) - If the machine is off, turn it on by
pressing the ON/OFF switch (2); the light (3)
will go on.
• Wait until the temperature ready light (5) goes
on; now the machine is ready to dispense
coffee.
5.1 With ground coffee
• (Fig.8A) - Place the filter (15) inside the
"Crema" filter holder (14).
• (Fig.10) - Fit the "Crema" filter holder into
the brew unit (8) from below.
• (Fig.11) - Turn the filter holder from left to
right until it locks into place.
• Let go of the handle of the "Crema" filter
holder. An automatic system will now cause
the handle to shift slightly back to the left.
This serves to ensure that the "Crema" filter
will function perfectly.
• (Fig.13) - Preheat the "Crema" filter holder
by pressing the coffee switch (4); water will
start to come out of the "Crema" filter holder
(this operation is only necessary for the first
cup of coffee).
• After allowing 50cc of water to flow out,
press the coffee switch (4) again to shut off
the flow of hot water.
• (Fig.15) - Remove the "Crema" filter holder
from the machine by turning it from right to
left and empty out any water inside it.
• Thanks to the special "Crema" filter holder
(14) supplied with your machine, you
need not change the filter when you switch
between one and two cups of coffee.
• (Fig.8B) - Pour 1 or 2 level measures of
ground coffee in the filter, depending on
whether you want to make one or two cups
of coffee; wipe the edge of the filter holder
clean of any coffee grounds.
• 24 •
4316036000 - SIN024X Rev00.indd 24
• (Fig.10) - Fit the "Crema" filter holder into
the brew unit (8) from below.
• (Fig.11) - Turn the filter holder from left to
right until it locks into place.
• (Fig.12) - Place 1 or 2 preheated cups
beneath the "Crema" filter; make sure that
you position them properly under the coffee
outlets.
• (Fig.13) - Press the coffee button (4).
• When you have dispensed the desired amount
of coffee, press the coffee button (4) again to
stop flow and remove the cups containing the
coffee (Fig.14).
• (Fig.15) - After making coffee, wait a few
seconds, remove the "Crema" filter holder
and empty out the used grounds.
Cleaning note: keep the coffee
filter clean by detaching it from the
"Crema" filter holder and washing it with
drinking water (Fig.16).
5.2 With coffee pods
• (Fig.9) - Fit the adaptor for pods (18) into
the "Crema" filter holder (14), then also put
the filter (17).
• (Fig.10) - Fit the "Crema" filter holder into
the brew unit (8) from below.
• (Fig.11) - Turn the filter holder from left to
right until it locks into place.
• Let go of the handle of the "Crema" filter
holder. An automatic system will now cause
the handle to shift slightly back to the left.
This serves to ensure that the "Crema" filter
will function perfectly.
• (Fig.13) - Preheat the "Crema" filter holder
by pressing the coffee switch (4); water will
start to come out of the "Crema" filter holder
(this operation is only necessary for the first
cup of coffee).
• After allowing 50cc of water to flow out, press
the coffee switch (4) again to shut off the flow
of hot water.
Making coffee
10/05/2004 11.57.18