Starting / Stopping The Engine - Stihl MS 271 Manual De Instrucciones

English
Starting / Stopping the
Engine
Versions with Easy2Start
This machine is extremely simple
and easy to start, even for
children.
To reduce the risk of serious or fatal
injury:
– do not allow children or other
unauthorized persons to attempt to
start or otherwise use the machine
– never allow children or
unauthorized persons access to the
machine
– never leave the machine
unattended while working or during
work breaks
– after work, store in a safe, secure
location out of the reach of children
and other unauthorized persons
34
Positions of the Master Control lever
STOP
0
Stop 0 – engine off – ignition is switched
off
Operating position F – engine is
running or can start
Warm start n – this position is for
starting the warm engine – the Master
Control lever returns to the operating
position when the throttle trigger is
squeezed
Cold start l – this position is for
starting the cold engine
Adjusting the Master Control lever
To adjust the Master Control lever from
the operating position F to cold start l,
press and hold down the throttle trigger
lockout and throttle trigger
simultaneously – set Master Control
lever.
To set the Master Control lever to warm
start n, first set it to cold start l, then
push the Master Control lever into the
warm start n position.
Switching to the warm start n position
is only possible from the cold start l
position.
Simultaneously pressing the throttle
trigger lockout and blipping the throttle
trigger causes the Master Control lever
to jump from the warm start n position
to the operating position F.
To switch off the engine, set the Master
Control lever to Stop 0.
Position choke shutter closed l
– if the engine is cold
– if the engine stalls during opening of
throttle after starting
– if the fuel tank has run empty
(engine stalled out)
Position starting acceleration n
– if engine is warm (once the engine
has been running for approx. one
minute)
– When the engine has turned over
for the first time
– after ventilation of the combustion
chamber, if the engine was flooded
Fuel pump
Press the fuel pump bulb several times –
even if it is still full of fuel:
– When starting for the first time
– If the fuel tank has run empty
(engine stalled out)
MS 271, MS 291, MS 291 C