Step 3: Unpacking And Moving The Range - Thermador PRO GRAND PROFESSIONAL Serie Manual De Instalación

Electrical Supply
Installation of the range must be planned so that the rough-
in of the terminal block for the receptacle will allow
maximum clearance to the rear of the unit. To minimize
binding when the unit is connected to the receptacle or
terminal block, orient the receptacle and slide back into
position.
When the power supply cord is connected to the mating
receptacle, the combined plug/receptacle connection
should protrude no more than 2" (51mm) from the rear wall,
see Figure 5.
Step 3: Unpacking and Moving
the Range
Unpacking the Range
1. Remove the outer carton and packing materials from
the shipping pallet but leave the adhesive-backed foam
layer over brushed-metal surfaces, to protect finish
from scratches, until the range is installed in its final
position.
2. Remove the door(s) (see "Step 4: Door Removal and
Adjustment" on page 11). This will create an estimated
reduction in the weight as shown in Table 1 and allow
the range to pass through 30" (762 mm) doorways (see
clearances beginning on page 6).
3. The grates, griddle plate, burner caps, and oven racks
must be removed to facilitate handling. Do not remove
the griddle element and tray assembly.
Figure 5: Wall Connection
Shipping Weight
Weight without packing
materials
Without door(s), burner caps,
and oven racks
Moving the Range
CAUTION!
DO NOT lift the range by the oven door's
handle, as this may damage the door hinges
and cause the door to fit incorrectly.
DO NOT lift the appliance by the range's
control panel.
The unit is heavy and should be handled
accordingly. Proper safety equipment such as
gloves and adequate manpower of at least
two people must be used in moving the range
to avoid injury and to avoid damage to the
unit or the floor.
Rings, watches, and any other loose items
that may damage the unit or otherwise might
become entangled with the unit should be
removed.
Hidden surfaces may have sharp edges. Use
caution when reaching behind or under
appliance.
DO NOT use a hand truck or appliance dolly
on the back or front of the unit. Handle from
the side only.
Due to the weight, it is strongly recommended that a
furniture dolly with soft wheels or an air lift should be used
to move this unit. The weight must be supported uniformly
across the bottom.
All ranges are held to the pallet by (4) bolts through a wood
block center. The two front pallet bolts are accessible only
after removing the Door Trim located beneath the doors.
36" 48"
RANGE RANGE
420 lbs 590 lbs
(191 kg) (268 kg)
360 lbs 530 lbs
(163 kg) (240 kg)
260 lbs 390 lbs
(118 kg) (177 kg)
Table 1: Range Weight
English 9