Fuel Cover
2
1
Jet Nozzle
Fuel Cell
Battery
Latch
REPLACING THE FUEL CELL
If the Fuel Gas is running out, the nails cannot be driven.
WARNING:
● Be sure to release the Trigger.
● Do not press the Contact Arm against the object.
q Push up and pull the Fuel Cover to this side to open it.
w Nip the Metering Valve and remove the used Fuel Cell.
e Set the new Fuel Cell.
(See Page 18 for the setting method)
REPLACING THE BATTERY
If the Battery is running out, the red LED of the tool will be turned on.
WARNING:
● Be sure to remove the Fuel Cell.
● Release the Trigger.
● Do not press the Contact Arm against the object.
q Firmly holding the main body, press the latches on both sides of the Battery to
remove it.
w Set the newly charged Battery into the main body until it has clicked.
(See Page 15 for the charging method)
e Set the Fuel Cell.
(See Page 18 for the setting method)
22