System Settings (Settings) - Cameo OPUS SP5 Manual De Usuario

SYSTEM SETTINGS (Settings)

Starting from the main display, press ENTER to go to the main menu. Use the UP and DOWN control keys to select the System Settings
menu and press ENTER.
This will take you to the submenu for setting the submenu options, see table (select via UP and DOWN, confirm via ENTER, change status via
UP and DOWN, confirm via ENTER):
Settings (bold = factory setting)
Display Display settings
DMX Fail Operating mode for DMX
signal interruption
Dimmer Curve Select the dimmer curve
LED Frequency Sets the LED PWM frequency
Pan/Tilt Configures the device head
B.O. Moving Automatic blackout when
head moves
Fixture Type Device type
Reverse OFF
ON
Backlight OFF
ON
Black
Hold
Auto
Linear
Exponential
Logarithmic
S-curve
650Hz, 1530Hz,
3600Hz, 12KHz, 25KHz
Pan Reverse OFF
ON
OFF
Tilt Reverse
ON
Pan Angle 630
540
Feedback OFF
ON
OFF
ON
ProfileModule
SpotModule
Display does not rotate
Display rotates by 180° (when installed
overhead)
Deactivates display backlight after approx. 30
seconds of inactivity
Display backlight permanently on
activates Blackout
Last command is held
Activates Auto mode
The light intensity climbs linearly with the
DMX value
The light intensity can be set finely in the
lower DMX value range and roughly in the
upper DMX value range
The light intensity can be set roughly in the
lower DMX value range and finely in the upper
DMX value range
The light intensity can be set finely in the
lower and upper DMX value ranges and
roughly in the medium DMX value range
Pan movement direction does not reverse
Pan movement direction reverses
Tilt movement direction does not reverse
Tilt movement direction reverses
Pan angle 630°
Pan angle 540°
Automatic position correction deactivated
Automatic position correction activated
No blackout when head moves
Blackout when head moves
11