Shutdown Instructions; Winterize The Machine - GENERGY Sella Instrucciones De Uso

15. The maximum engine RPM has been set by the manufacturer. Tempering with engine governor will
void pump warranty.
16. Do not exceed the manufacturer's maximum pressure by increasing the unloader
adjustment. (This will void pump warranty.)

Shutdown Instructions

1. Run only clean water though the entire chemical/detergent system, then turn chemical / detergent
valve to OFF. INJECTION HAZARD: Fluids under high pressure from spray or leaks can penetrate
the skin and cause extremely serious injury, including death or the need for amputation.
2. If engine is equipped with throttle lever, position lever to IDLE.
3 Turn engine switch to OFF.
4. If engine is equipped with a fuel valve, turn valve to CLOSED position.
5. Turn water supply to OFF.
6. Open gun to relieve pressure, and drain as much water as possible.
7. Remove inlet hose.
8. For safety and your liability protection, remove high pressure hose and store gun/wand in a secure
place with this manual to eliminate possibility of unauthorized and untrained personnel from operating
the machine.

Winterize The Machine

Whenever your machine will be subjected to freezing temperatures, severe damage could occur caused
by freezing inside the components. To prevent costly repairs, follow these steps: (Freeze damage is NOT
covered by the manufactures warranty.)
1. Be sure the machine is OFF, water supply is disconnected, and pressure has been relieved.
2. Obtain a one-gallon container or NONTOXIC (RV) antifreeze.
3. Install a suction hose from the pump inlet (garden hose fittings) into the NONTOXIC antifreeze.
Following operation instructions, start the engine and squeeze trigger on spray gun allowing the
pump to draw antifreeze through the entire system. Once antifreeze appears at the end of wand, turn
the engine off.
4. Squeeze gun trigger to relieve pressure, and remove the high pressure hose, gun/wand and store in
a secure place with owners manual to eliminate unauthorized and untrained personnel from operating
the machine.
5. See engine owner's manual for proper engine storage.
6. When preparing to operate the pressure washer again, simply reconnect to pressure system water
supply, attach the high pressure hose assembly, turn the water to "ON" and squeeze trigger allowing
water to pass through the system. (Do not turn on pressure washer.) Once the liquid becomes clear
water at the end of the wand, you are ready to begin operating your pressure washer as referenced
in this manual.
It is prohibited to reproduce, copy or use this document without written permission from Stock Garden Spain (GENERGY), Spain, 2009.
26
GAS POWERED PRESSURE WASHER