Appliance Communication - Monogram ZIR241NPNAII Manual Del Usario

APPLIANCE COMMUNICATION

WI-FI Connect (for customers in the United States, its territories, and Canada)
Your refrigerator/freezer has a Connected Appliance
information label located behind the lowest door bin, as
shown, and can be connected to your WI-FI network,
allowing it to communicate with your smart phone for
remote monitoring, control and notifications. Please visit
monogram.com/connect to learn more about connected
appliance features, and to learn what connected appliance
apps will work with your Smart Phone.
To use your WI-FI, press the WI-FI pad on
the control panel. The WI-FI symbol will flash
during the connection process. It will remain
solid when a connection is made.
To turn off WI-FI, press and hold the WI-FI pad again.
REGULATORY INFORMATION
FCC/IC Compliance Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/television technician for help.
Labelling: Changes or modifications to this unit not expressly approved by the manufacturer could void the user's
authority to operate the equipment.
ConnectPlus module only (or similar communication module)
RF Exposure - This device is only authorized for use in a mobile application. At least 20 cm of separation distance
between the ConnectPlus device and the user's body must be maintained at all times.
10
Connected Appliance information label
located behind the lowest door bin
49-1000189 Rev.0