Ryobi P4510 Manual Del Operador página 7

APPLICATIONS
You may use this product for the purpose listed below:
 The power scrubber can be used to clean exterior and
interior surfaces.
 This product is not for commercial use.
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 9.
NOTE: This product is not recommended for use with RYOBI
ONE+ battery packs larger than 4.0Ah. If installed, large
capacity battery packs will prevent the battery cover from
closing completely exposing the battery and the battery port
to moisture, debris, and other contaminants.
 Unlock the tab and open the battery cover.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
 Close the battery cover and lock the tab.
 To remove, open the cover and depress the latches on
both sides of the battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
WARNING:
Do not operate the scrubber with the battery door open.
An open door could expose the battery and battery
compartment to wet conditions which could increase the
risk of electric shock.
SELECTING A BRUSH ACCESSORY
Selecting the correct type of brush accessory is important in
order to obtain the best performance from the power scrub-
ber. Select the brush accessory based on the application and
on the surface you wish to clean. Selecting the right brush
accessory will help you clean more efficiently and protect
the surface being cleaned. To reduce the risk of property
damage, always test the brush in an inconspicuous area of
a surface before beginning a project.
NOTE: A brush accessory with medium bristles is included
with your power scrubber. Brush accessories with hard and
soft bristles can be purchased where you bought this product.
OPERATION
BRUSH ACCESSORY SELECTION GUIDE
INSTALLING/REMOVING BRUSH
ACCESSORIES
See Figure 2, page 9.
 Remove the battery pack.
 Align the triangular hole in the brush accessory with the
triangular stud on the connector.
 Slide the brush accessory onto the connector.
 Hold the connector sleeve and rotate the brush accessory
counterclockwise to lock it in place.
NOTE: When locked, the triangular hole and triangular
stud will be misaligned.
 Hold the connector sleeve and rotate the brush accessory
clockwise to unlock and remove the brush accessory.
NOTE: When unlocked, the triangular hole and triangular
stud will be aligned.
STARTING/STOPPING THE POWER
SCRUBBER
See Figure 3, page 9.
To start the motor:
 Fully depress the on/off button to start the motor.
NOTE: When the motor is on, the brush accessory will
spin continuously.
To stop the motor:
 Fully depress the on/off button to stop the motor.
NOTE: When the motor is off, the brush accessory will
stop spinning.
7 – English
Soft Bristle (Blue)
Light Duty Cleaning
Medium Bristle (Green)
General Purpose Cleaning
Hard Bristle (Gray)
Heavy Duty Cleaning