Maintenance; Illustrations; Warning - Ryobi P4510 Manual Del Operador

OPERATING THE POWER SCRUBBER
See Figure 4, page 9.
 Select the appropriate brush accessory.
 Install the battery pack.
 Hold the scrubber firmly against the surface.
 Fully depress the on/off button to start the power
scrubber.
 Move the unit forward and back over the surface to be
cleaned.
NOTE: Move slowly when learning to use the unit and
when scrubbing tough or difficult stains.
NOTE: Do not press down on the unit or keep the unit
in one place over an extended period of time. Doing so
could damage the surface being cleaned.

WARNING:

When servicing, use only identical replacement parts.
Use of any other part could create a hazard or cause
product damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
To avoid serious personal injury, always remove the
battery pack from the tool when cleaning, performing
any maintenance, or when storing the tool.
ILLUSTRATIONS START ON PAGE 9 AFTER
FRENCH AND SPANISH LANGUAGE SECTIONS.
OPERATION
 When scrubbing is complete, fully depress the on/
off button to turn the motor off, and wait for the brush
accessory to stop spinning.
 Remove the battery pack.
 Remove the brush accessory as described earlier and
clean thoroughly.
NOTICE:
Dirt and debris can damage delicate surfaces. Thoroughly
rinse the brush accessory before use and continue to do
so at regular intervals during use. Thoroughly clean the
brush accessory after use. Allow to dry and always store
brush accessory without bending the bristles.

MAINTENANCE

GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and can be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
REPLACING THE BRUSH ACCESSORY
See Figure 2, page 9.
After extended use, the brush accessory may wear and
need replacing. If you drop the tool and damage the brush
accessory it may also be necessary for you to replace it.
Refer to Installing/Removing Brush Accessories earlier
in this manual.
8 – English