Pro-Lift T-5300 Manual De Piezas E Instrucciones De Funcionamiento página 3

ASSEMBLY
1. Attach Hydraulic Unit to receiver platform using (2)
M6 Socket Head Cap Screws and nuts.
2. Insert the Bottle Jack Ram Pin to connect the Bottle
Jack to the cross head (If holes do not line up, twist
the Bottle Jack Ram until they are aligned).
3. Install Lift Pedal into Bottle Jack Pedal Sleeve and
secure with M5 Phillips Head Screw.
4. Install Lift Handle Yoke into frame using (2) M6 Hex
Head bolts and nuts. Insert Handle and twist to se-
cure pin in Yoke slot (ref. illustration).
5. Install Wheel Baskets using (2 each) M10 hardware
provided.
6. After assembly, ensure lift rolls freely, lifts, locks and
lowers easily, and that Bottle Jack operates smoothly
before putting into service. Familiarize yourself with
operation of Height Locking Lever and Lift Pedal.
Bottle Jack Ram Pin
Nuts
OPERATION
1. Position mower tires securely on Wheel Baskets, centering the load on lift.
2. To familiarize yourself with basic operation, use the notched end of Lift Handle to engage and turn the release
valve:
a. Clockwise until firm resistance is felt to further turning. This is the 'CLOSED' release valve position used to
raise the ram plunger.
b. Counter-clockwise, but no more than 1 turn from the closed position. This is the 'OPEN' release valve position
used to lower the ram plunger.
• Study, understand and follow all instructions
before operating this device.
• Use of this product is limited to lifting, holding and
lowering loads consisting of a single mower
compatible with the lift platform. Incompatibility is
evident when the loaded mower wobbles, appears
unstable, and/or does not securely engage the
wheel baskets.
• Restraining an incompatible load will not make the
load secure and may cause unexpected loss of
load.
• Do not exceed rated capacity.
• Use only on hard, level surfaces.
• Center load on lift platform.
• Immediately after lifting load, ensure lift mechani-
cal load holding device is engaged.
• Never work on, under or around a load that is not
stable or secure.
• Keep operator's and bystander's head, hands and
feet away from lift arms when raising and lowering.
Socket
• No alterations shall be made to this product.
Head Cap
• Only attachments, restraints or adapters supplied
Screw
by the manufacturer shall be used.
• Failure to heed these messages may result in
personal injury and/or property damage.
Wheel Baskets
Hex Head
Bolts and Nuts
3
WARNING
!
Hex Head
Bolts and Nuts