RIDGID MOB12000 Manual Del Usuario página 11

SP7010 MOB12000.qxp_SP7010 11/22/16 12:08 PM Page 11
Operation (Continued)
To reduce the risk of electric shock, this
Vac has an ALCI (Appliance Leakage
Current Interrupter) device with a
polarized plug (one blade is wider than
the other). The ALCI may need to be
reset if it detects current leakage or if
the test button is pressed on the device.
The polarized plug will fit in a polarized
outlet only one way. If the plug does not
fit fully in the outlet, reverse the plug.
If it still does not fit, contact a qualified
electrician to install the proper outlet.
Do not change the plug in any way.
Note that the ALCI is a protective device
that may make the Vac temporarily
inoperable under some abnormal
conditions such as immersing the base
of the Vac in water. Before any use of
the Vac involving wet pickup, or if the
base has previously been placed in
standing water or on a wet floor,
the ALCI should be tested as follows:
1. With the ALCI plugged in, press the
test button.
2. The reset button will pop up. If not,
do not use Wet/Dry Vac.
3. Press reset button to restore power.
WARNING: Electric shock hazard
- do not place and operate vacuum
in standing water.
After you plug the ALCI plug into the
outlet, turn the Wet/Dry Vac on by
pushing the foot pedal down, located
at the front bottom of drum/caddy base.
ON/OFF
Foot Pedal
Vacuuming Dry Materials
1. The filter must always be in correct
2. Your Wet/Dry Vac comes with the
NOTE: A dry filter is necessary to pick
up dry material. It is not recommended
to vacuum dust when the filter is wet,
the filter will clog quickly and be difficult
to clean. Allow filter to dry before storing.
TEST
RESET
ALCI
Plug
11
PUSH DOWN TO TURN
"ON" AND "OFF"
position to reduce the risk of leaks
and possible damage to Vac.
VF5000 Filter installed. When using
your Vac to pick up very fine dust,
it will be necessary for you to empty
the drum and clean the filter at more
frequent intervals to maintain peak
Vac performance.