External Cleaning; Filter Cleaning/Replacement; Specifications - Furrion FHO23SACR-BL Manual De Instrucciones

External Cleaning

Wipe the range hood frequently with warm soapy water using
a mild detergent.
NOTE: Never use scouring pads or abrasive cleaners. Never
use excessive amounts of water when cleaning particularly
around the control panel.

Filter Cleaning/Replacement

WARNING
This appliance can be a possible fire hazard if the grease
and charcoal filters are not cleaned and replaced as
recommended.
Metal Holder
The metal holder to fix charcoal filter, and should be cleaned
approximately once every month or more often if the range
hood is used for more than 3 hours a day. Do not use the
dishwasher to wash.
To remove the metal holder:
1. To open the filter panel, press in on the two locking latches
and pull downward to remove the filter panel from the vent
hood.
2. Lift the filter panel from the rear latches and place on a
protected surface. (Fig. 12 and Fig. 13)
Fig. 12
3. To remove the filter, lift up on the filter rod tabs (6 total)
and remove the rod from the filter panel. (Fig. 14)

Specifications

23 " (598mm)
10" (252mm)
6
Fig. 13
4 " (119.3mm)
3 " (82mm)
4 " (119.3mm)
Fig. 14
4. Separate the metal rod, the metal holder and the charcoal
filter from the cover. (Fig. 15)
Charcoal Filter
Fig. 15
5. Dip the metal holder into mild soapy water and wash by
hand. (Do not use the dishwasher to wash.)
6. Allow the metal holder to dry completely before replacing.
Charcoal Filter
This appliance is designed with a charcoal filter equipped to
absorb smells and unwanted odors.
The charcoal filter cannot be cleaned, we recommend they
should be replaced approximately every three months or
more often if the range hood is used for more than three
hours per day. To replace the charcoal filter:
1. Repeat steps 1 to 3 in section 'Metal Holder' to remove the
metal rods and metal holder first.
2. Remove the saturated charcoal filter and replace with a
new one. (Fig. 16)
Fig. 16
3. The replacement charcoal filter can be obtained from your
local service center.
4. Repeat steps 4~1 in 'Metal Holder' to replace the filter
panel. See figure 15 for the replacement process of the
filter and metal holder.
Specifications
Connection Voltage
Power Consumption
Lighting Power Consumption
Overall Dimension
(W x H x D)
Vent collar dimensions
(W x H x D)
Metal Holder
Metal Rod
Charcoal Filter
12 VDC
12 W
0.95 W
231/2" x 173/4" x 43/4"
(598 x 448.7 x 119.3 mm)
10" x 1" x 31/4"
(252 x 25 x 82 mm)