Westinghouse LBA40120 Manual De Instrucciones página 5

CHARGER SAFETY INFORMATION
WARNING: READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instructions
listed below, may result in electric shock, fire and/or serious personal injury.
• Before using charger, read all instructions and cautionary markings in this manual, on charger,
battery, and product using battery to prevent misuse of the products and possible injury or damage.
WARNING: Charge only one lithium-ion rechargeable battery at a time. Other types of batteries
may burst, causing personal injury or damage
• Do not use charger outdoors or expose to wet or damp conditions. Water entering charger will
increase the risk of electric shock.
• Use of an attachment not recommended or sold by the battery charger manufacturer may result in
a risk of fire, electric shock, or injury to persons. Following this rule will reduce the risk of electric
shock, fire, or serious personal injury.
• Do not abuse cord or charger. Never use the cord to carry the charger. Do not pull the charger
cord rather than the plug when disconnecting from receptacle. Damage to the cord or charger
could occur and create an electric shock hazard. If cord or charger is damaged, have the charger
replaced by an authorized serviceman.
• Make sure cord is located so that it will not be stepped on, tripped over, come in contact with sharp
edges or moving parts or otherwise subjected to damage or stress. This will reduce the risk of
accidental falls, which could cause injury, and damage to the cord, which could result in electric
shock.
• Keep cord and charger from heat to prevent damage to housing or internal parts.
• Do not let gasoline, oils, petroleum-based products, etc. come in contact with plastic parts. They
contain chemicals that can damage, weaken, or destroy plastic
• Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so
could result in objects being thrown into your eyes resulting in possible serious injury.
• An extension cord should not be used unless absolutely necessary. Use of improper extension cord
could result in a risk of fire and electric shock. If extension cord must be used, make sure:
a. That pins on plug of extension cord are the same number, size and shape as those of plug on
charger.
b. That extension cord is properly wired and in good electrical condition; and
c. That wire size is large enough for AC ampere rating of charger as specified below:
Cord Length (Feet)
Cord Size (AWG)
• Do not operate charger with a damaged cord or plug, which could cause shorting and electric
shock. If damaged, have the charger replaced by an authorized serviceman.
• Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any
way. Take it to an authorized serviceman for electrical check
• to determine if the charger is in good working order.
• Do not disassemble charger. Take it to an authorized serviceman when service or repair is required.
Incorrect reassembly may result in a risk of electric shock or fire.
• Unplug charger from outlet before attempting any maintenance or cleaning to reduce the risk of
electric shock.
• Disconnect charger from the power supply when not in use. This will reduce the risk of electric
shock or damage to the charger if metal items should fall into the opening. It also will help prevent
damage to the charger during a power surge.
• Risk of electric shock. Do not touch uninsulated portion of output connector or uninsulated battery
terminal.
• Save these instructions. Refer to them frequently and use them to instruct others who may use
this tool. If you loan someone this tool, loan them these instructions also to prevent misuse of the
product and possible injury.
25' 50'
16 16
100'
16
5