Cleaning And Maintenance - Bresser MyTime Thermo-/Hygro 8020310 CM3000 Instrucciones De Uso

Ocultar thumbs Ver también para MyTime Thermo-/Hygro 8020310 CM3000:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Automatic time setting via DCF time signal
After inserting the battery the time will be set auto-
matically via DCF signal. This process may take a few
minutes. During this process the clock hands will turn
several times with interruption until they will display the
right time.
Initiate to receive the DCF time signal manually
NOTE!
Use this function when e.g. automatic summer/winter
time change does not work or the wall clock temporarely
receives no time signal.
1. Press and hold the REC button (8) for 3 seconds to
start manual search for the DCF signal.
2. The clock hands will move to their start position
(12:00 a.m.) and a the wall clock then tries to receive
the signal.
3. Wait approx. 2-5 minutes until the current time will
be displayed.
Manual time setting
NOTE!
It is necessary to set the time manually in places where
no radio signal is received.
1. Press and hold the M.SET button (9) for approx. 3
seconds.
2. When the minutes hand starts moving you can the set
the time manually:
• Press the M.SET button shortly to set the time in
minutes steps.
• Press and hold the M.SET button to set the time con-
tinously.
3. Release M.SET button to stop manual setting and
save the time automatically and exit manual time set-
ting mode.
TEMPERATURE AND HUMIDITY DISPLAY
Temperature and humidity measurement work manually.
It may take a few minutes until the value that is currently
measured will be displayed.
MOUNTING/POSITIONING
NOTE!
Make sure you have mounted or placed the device in a
safe way. Otherwise the device may fall down and heavy
damages can occur for which the manufacturer is not
liable.
The wall clock can be mounted on walls with the wall
mount (5).
TROUBLESHOOTING
Transmission collision
Signals from other household devices, such as door
bells, home security systems and entry controls, may in-
terfere with those of this product and cause temporarily
reception failure. This is normal and does not affect the
general performance of the product. The transmission
of the radio signal will resume once the interference re-
cedes.
Other malfunctions
If there is no response from the wall clock by keystrokes
or if any other malfunctions occur perform the following
steps.
NOTE!
With this procedure all received data will be deleted.
1. Press RESET button (7) with a pointed instrument
(e.g. pen).
2. The clock hands will move to their start position
(12:00 a.m.) and the wall clock then tries to receive
the signal.
3. Wait approx. 2-5 minutes until the current time will
be displayed.

CLEANING AND MAINTENANCE

Before cleaning the device, disconnect it from the power
supply (remove batteries)!
Only use a dry cloth to clean the exterior of the device.
To avoid damaging the electronics, do not use any clean-
ing fluid.
Protect the device from dust and moisture. The batteries
should be removed from the unit if it has not been used
for a long time.
DISPOSAL
Dispose of the packaging materials properly, ac-
cording to their type, such as paper or cardboard.
Contact your local waste-disposal service or environ-
mental authority for information on the proper disposal.
Do not dispose of electronic devices in the house-
hold garbage!
As per Directive 2002/96/EC of the European Parliament
on waste electrical and electronic equipment and its ad-
aptation into German law, used electronic devices must
be collected separately and recycled in an environmen-
tally friendly manner.
DE
EN
FR
IT
ES
7

Publicidad

Tabla de contenido
loading

Tabla de contenido