Pairing A Bluetooth Device; Pairing A Bluetooth Device Using Nfc - ION Block Rocker Bluetooth Guía De Inicio Rápida

12. Antenna: Adjust this telescoping FM antenna to get the best radio reception.
Note: To prevent accidental damage, we recommend rotating the antenna only when it is extended
horizontally. Also, retract the antenna when the Tuner is not in use.
Note: To adjust AM reception, move entire unit.
13. Power Cable Input (IEC): Insert the included power cable here to charge the unit. Note that the Block
Rocker Bluetooth can run off the power adapter while it simultaneously charges the battery. The charge
indicator illuminates when the battery is charging.
14. Voltage Selector*: If your unit has a voltage selector switch, change its setting only when necessary
(e.g., when traveling to a country or region with a different voltage). Selecting an improper voltage
setting can damage the unit. To change its setting, only remove *one* screw of the cover and slide it
aside to expose the selector.
15. Power ON/OFF Switch: Turns Block Rocker Bluetooth on or off. Please note that while Block Rocker
Bluetooth is connected to a power source, it does not need to be powered on to charge the battery.
16. Battery Level Indicator: While the unit is powered ON and unit is not plugged in, these four lights
indicate the power left in the battery. Battery life varies based on volume and usage.
Troubleshooting
If the sound is distorted: Try lowering the volume control of your sound source or musical instrument. Also,
try to reduce the overall volume of Block Rocker Bluetooth.
If there is too much bass: Try adjusting the tone or EQ control on your sound source to lower the bass
level. This will allow you to play the music louder before clipping (distortion) occurs.
If there is a high-pitched whistling noise when using microphones: This is probably feedback. Point the
microphones away from the speaker.
If there is poor AM reception: To adjust AM reception, move entire unit.
If you can't hear the microphone over the music volume: Turn down the music volume from your source.

Pairing a Bluetooth Device

1. Turn on your Bluetooth device.
2. Power on Block Rocker Bluetooth and it will automatically go into pairing mode to search for Bluetooth
devices. You will know you are in pairing mode when the LED is blank.
3. If your Bluetooth device is not able to pair to the amp, press the disconnect button on the amp to break
previous Bluetooth connections and reset the Bluetooth module.
4. Navigate to your Bluetooth device's setup screen, find "Block Rocker" and connect.
Note: If your Bluetooth device prompts for a pairing code, enter '0000'.
5. Block Rocker Bluetooth LED will light up solid when it is 'paired'.
Note: Users should consider updating their OS if experiencing trouble with pairing or playing music.
6. To disconnect pairing, press the 'Disconnect' button on Block Rocker Bluetooth.
7. To connect to another Bluetooth device, repeat steps 3-4.
Note: Maximum range will be achieved when using devices with Bluetooth 4.0.

Pairing a Bluetooth Device Using NFC

NFC (near-field communication) allows data exchange from devices, such as pairing, by gently bumping
them together. Check in your device's manual to see if this feature is supported.
To use NFC to pair with Block Rocker Bluetooth:
In order to use NFC, your device must be turned on and unlocked.
1.
Enter your device's Settings menu and check that NFC is turned On (one time step).
2.
Power on Block Rocker Bluetooth.
3.
Gently bump your device against the 'N' logo located on Block Rocker Bluetooth's top panel.
4.
Follow the pairing instructions that appear on your phone. If a passcode is required, enter "0000".
5.
To unpair, gently bump your device against the 'N' logo located on Block Rocker Bluetooth's top panel.
6.
5