Accessories
Accessories Supply
Check that you have the accessories and items shown
Operating Instruction book
Power supply cord
Remote Control Batteries
Requires two R6 batteries.
1. Pull and hold the hook, then open
the battery cover.
Helpful Hint:
For frequent remote control users, replace old batteries with Alkaline
batteries for longer life.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Disposal of batteries should be in an environment-friendly manner.
Observe the following precaution:
1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: "Zinc Carbon" with "Alkaline").
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts sporadically or stops operating the Display set.
6. Do not burn or breakup batteries.
Batteries must not be exposed to excessive heat such as sunshine, ¿ re or the like.
6
CD-ROM
(Operating
instructions)
Clamper × 1
TMME289
2. Insert batteries - note correct
polarity ( + and -).
"R6 (UM3)" size
-
+
+
-
Remote Control
Batteries for the Remote
Transmitter
Control Transmitter
N2QAYB000691
(R6 (UM3) Size × 2)
3. Replace the cover.