Operating The Brakes; Transfer In And Out The Scooter; Correct Position In The Scooter; Driving The Scooter - Vermeiren Carpo Limo Manual De Instrucciones

2.4

Operating the brakes

To apply the electromagnetic brakes:
1. Let go of the speed or drive lever, the electromagnetic brake in the motor will be activated, the
scooter will stop.
2.5

Transfer in and out the scooter

2.6

Correct position in the scooter

Some recommendations for a comfortable use of the scooter:
1. Position your backside as close as possible to the backrest.
2. Make sure your upper legs are horizontal.
2.7

Driving the scooter

L
WARNING:
Risk of burns – Be careful when driving in hot or cold environments
(sunshine, extreme cold, saunas, etc.) for a sufficient amount of time and when
touching - Surfaces can assume the environment temperatures.
L
WARNING:
Risk of unsafe settings - Use only the driving characteristics described in
this manual.
2.7.1 Preparing the scooter for use
When you use your scooter for the first time, make sure that it is standing on level ground. All wheels
must be in contact with the ground.
1. For first time use, fully recharge the batteries.
2. Make sure that the motor is engaged.
To apply the manual brakes (optional):
1. Pull the brake lever  towards the handgrip.
2. Release the brake lever .
The manual brake tightness can be adjusted by the
brake cable adjuster.
1. Park the scooter as close as possible to the place where you
want to transfer.
2. Check that the control panel (scooter) is switched off.
3. Put the armpad on the side you want to transfer upwards.
4. Transfer to / from the seat of the scooter.
Page 11
Carpo Limo
2015-07