Designated Use; Unpacking The Appliance; Overview Of The Components / Scope Of Delivery; Installation - Profi Cook PC-UM 1207 Manual De Instrucciones

• Objects like spoons or scrapers never may be in the mixing jar
during operation.

Designated Use

This appliance is used for:
• Mixing of liquids
• Chopping firm foodstuffs
• Crushing ice
• Producing of flours
It is intended for the use in private households and similar
applications.
It is imperative that short-time operation is observed.
It is only to be used as instructed in this user manual. The
appliance is not intended for commercial use.
Any other use shall be considered as not intended use and
can lead to material damage or even personal injury.
The manufacturer shall not be liable for damages caused by
not intended use.

Unpacking the Appliance

1. Remove the packaging of the appliance.
2. Remove all packaging material such as plastic film, filler
material, cable ties and box packaging.
3. Check that all parts are in the box.
4. If the packaging content should be incomplete or if dam-
ages should be noticeable, do not operate the appliance.
Return it to the distributor immediately.
NOTE:
Dust or production residues may still be found on the
appliance. We recommend that you clean the appliance
as described under "Cleaning".
Overview of the Components /
Scope of Delivery
1 Refill opening cap / measuring cup
2 Mixing jar lid with refill opening
3 Mixing jar
4 Knife block
5 Sealing ring for the knife block
6 Screw-cap
7 Base section with motor
8 Rotary knob and button
Not Shown
Sealing ring for the lid
PC-UM1207_IM

Installation

Mixing Jar
Place the mixing jar onto the motor housing. Note the sym-
bols on the mixing jar and the motor housing.
NOTE:
The mixing jar fits onto the motor housing in various
positions. The safety switch is only shut when the two
triangles are aligned with one another.
Lid
1. Make sure that the sealing ring is attached to the lid.
2. Place the lid on the mixing jar so that the flap on the
cover is located to the left of the spout opening.
3. Press the lid firmly onto the mixing jar. It must seal the
mixing jar completely.
4. Turn the cover clockwise until it stops. The cover flap is
now directly over the spout opening. Check to ensure the
cover is shut tight.
5. Insert the cap into the refill opening of the lid. Pay
attention to the guide lugs on the screw-cap. Turn the
screw-cap clockwise as far as it will go. The clasp must
snap into place.
NOTE:
The refill opening cap can also be used as a measuring
cup.

Notes for Use

CAUTION:
The glass may crack if the temperature is too high! Do
not fill with liquids above 60 °C.
• Place the appliance on a firm and flat surface. Position it
is such that it cannot tip over.
• Only switch on the appliance if the mixing jar is closed
with the lid. The refill opening in the lid must also be
closed.
• Do not overfill the mixing jar! You can fill it to a maximum
of 1.75 litres. Use the scale on the jug.
• Froth requires a large capacity. Reduce quantities of
liquids which produce a lot of froth.
• Keep one hand on the lid if you are crushing ice or if
there is a large quantity of ingredients.
• Cut the food to be mixed into small pieces beforehand.
Electric Connection
1. Set the rotary knob to the OFF position.
2. Before inserting the power plug into the outlet, check
that the mains voltage to be used matches that of the
37
21.02.20