Briteq LDP-COBWASH WW Serie Manual De Instrucciones página 5

ENGLISH
 In the event of serious operating problems, stop using the fixture and contact your dealer immediately.
 The housing and the lenses must be replaced if they are visibly damaged.
 Please use the original packing when the device is to be transported.
 Due to safety reasons it is prohibited to make unauthorized modifications to the unit.
Important: Never look directly into the light source! Don't use the effect in the presence of persons suffering
from epilepsy.
DESCRIPTION:
PROJECTOR
Descriptions are made for the LDP-COBWASH50 WW/CW. All points are identical for the LDP-
COBWASH100 WW/CW, except where indicated.
1. POWER INPUT: mains input cable using a special 4pin IP-rated connector. Connect it to the mains
output cable of the previous projector in the line or use the supplied conversion cable to connect the
projector directly to a wall outlet socket.
2. DMX INPUT: DMX input cable using a special 3pin IP-rated connector. Connect it to the DMX output
cable of the previous LDP-projector in the line or use the supplied conversion cable to connect the unit to
a standard XLR-output of a projector or DMX controller.
3. POWER OUTPUT: mains output cable using a special 4pin IP-rated connector. Connect it to the power
input cable of the next projector in the line. Maximum power for the power line: 10A (2300W)
4. DMX OUTPUT: DMX output cable using a special 3pin IP-rated connector. Connect it to the DMX input
cable of the next LDP-projector in the line or use the supplied conversion cable to connect the unit to a
standard XLR-input of a DMX-projector.
5. DISPLAY & BUTTONS: Backlit alphanumeric LCD-display and waterproof touch keys to select different
options of the setup menu:
 MENU-button: used to browse the different menu options or to exit a menu option.
 DOWN-button: used to go to the next menu option or to decrease a parameter value.
 UP-button: used to go to the previous menu option or to increase a parameter value.
 ENTER-button: used to select a menu option or confirm a setting.
6. HANGING BRACKETS: with knobs or Allen bolts on both sides to fasten the unit. The projector should
be fixed to a flat wall, on the ground or on the ceiling using at least two adapted screws.
7. SAFETY HOLE: used to attach a safety cable when the unit is rigged, see paragraph "overhead rigging".
8. BARN DOOR fixing holes: used to fix the optional BARN DOOR.
 LDP-COBWASH 100WW/CW: not applicable, barn doors already installed.
9. IR-RECEIVER: receives the commands from the included IR-remote. (remote functions: see further)
10. COB led: special high power led chip, avoid looking directly in the light from a close distance.
11. TEMPERED GLASS: makes the enclosure waterproof. Replace the glass immediately if it's scratched or
broken.
BRITEQ
®
3/50 LDP-COBWASH 50 + 100 (WW/CW)
OPERATION MANUAL