Maintenance; Environmental Protection - RS Components 754-1915 Instrucciones De Uso

▪ When drilling through holes, place a block of wood
behind the work piece to prevent ragged or splintered
edges on the back side of the hole.
All drilling operations
▪ Use only sharp drill bits.
▪ Mark off the centre of the hole using a centre punch
or nail.
sCReWING / UNsCReWING
Select the appropriate torque by placing one of the num-
bers, marked on the torque adjustment collar (8), against
the arrow on the tool housing.
Insert the necessary bit.
WARNING: Over-tightening can result in the
screw breaking or damage to the end of the driver bit.
WARNING: If the machine is held at an angle
to the screw being tightened, the head of the screw
may be damaged, or the specified torque may not be
transmitted to the screw. Always keep the machine
and the screw being tightened in a straight line.
IX - Maintenance
WARNING: Always set the forward/reverse
switch (6) in central position before any work on the
machine e. g. fitting and removing a battery, tool
change, transport, maintenance and storage.
Regularly check that all the fixing screws are tight. They
may vibrate loose over time.
CleANING
For safe operation always keep the machine and its ven-
tilation slots clean.
Regularly check to see if any dust or foreign matter has
entered the grills near the motor and around the switch-
es. Use a soft brush to remove any accumulated dust.
Wear safety glasses to protect your eyes whilst cleaning.
If the body of the tool needs cleaning, wipe it with a soft
damp cloth. A mild detergent can be used.
WARNING: Never use alcohol, petrol or other
cleaning agent. Never use caustic agents to clean
plastic parts.
WARNING: Water must never come into con-
tact with the tool.
Original instructions
RS-754-1915-pages-BR2 7.2Li.indd 9
CHARGeR CleANING INstRUCtIONs
WARNING: Disconnect the charger from the
AC outlet before cleaning.
▪ Dirt and grease may be removed from the exterior of
the charger using a cloth or soft non-metallic brush.
Do not use water or any cleaning solutions.
ImPORtANt! To assure product safety and reliability,
repairs, maintenance and adjustment (including brush
inspection and replacement) should be performed by
certified service centres or other qualified service or-
ganisations, always using genuine replacement parts.
X - Environmental protection
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
for eU-countries only:
Do not dispose of the power tool into household
waste! According to the guidelines 2002/96/EC, power
tools, which are not usable, should be recycled.
batteries:
Do not dispose of the power tool or the bat-
tery into household waste, fire or water. All
type of batteries should be sorted for environ-
mental-friendly recycling or destroyed.
for eU-countries only:
Defective or worn out batteries must be recycled accord-
ing to the guidelines 91/157/EEC.
9
EN
8.6.2012 . 14:55:54 .