Publicidad
Installation Instructions/Instrucciones de Instalación
Back
LACAVA LLC
1. Place the cartridge bodies up through their designated
Back
holes. Then slide a handle base onto each extension
and thread onto the brass body. Make sure the set screw
holes are facing towards the back.
2. Tighten each locking nut upwards as far as possible by
hand until tight (DO NOT overtighten. avoid damage
to mounting surface).
3. Slide a lever handle onto each cartridge extension,
taking note as to which one is marked for hot, cold, &
diverter. Keep in place by tightening each set screw
using the provided Allen wrench.
4
Publicidad
