Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
IMPORTANT: Read entire operator's manual before you
attempt to assemble or operate your new pressure washer.
Remove Pressure Washer From
Carton
1.
Remove parts bag packed with pressure washer.
2.
Slice two corners at end of carton from top to
bottom so panel can be folded down flat, then remove
all packing material.
3.
Roll pressure washer out of carton.
Carton Contents
Items in the carton include:
• Main Unit
• Safety Goggles
• Handle
• High Pressure Hose
• Spray Gun
• Adjustable Nozzle Extension
• Oil Bottle
• Parts Bag (which includes the following):
•
Operator's Manual
•
Engine Operator's Manual
•
Owner's Registration Card
•
Handle Fastening Hardware Kit (which includes):
•
Carriage Bolts (2)
•
Plastic Knobs (4)
•
"L" Hooks (2)
PREPARING PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged, call the
pressure washer helpline at 1-800-317-7833.
To prepare your pressure washer for operation, you
will need to perform these tasks:
1.
Fill out and send in registration card.
2.
Attach handle to main unit.
3.
Add oil to engine crankcase.
4.
Add fuel to fuel tank.
5.
Connect high pressure hose to spray gun and pump.
2450 PSI Pressure Washer
6.
Connect water supply to pump.
7.
Attach nozzle extension to spray gun.
Attach Handle to Unit
1.
Place handle assembly onto handle supports connected
to main unit. Make sure holes in handle align with
holes on handle supports (Figure 1).
Figure 1 — Attach Handle to Base
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2.
Insert carriage bolts through holes from outside of the
unit and attach a plastic knob from inside of unit
(Figure 2).Tighten by hand.
Figure 2 — Secure Handle
3.
Insert one "L" hook through hole just above billboard
on left side of handle (viewing from front of unit). Hold
hook in place and attach a plastic knob from inside of
unit (Figure 3).Tighten by hand.
Figure 3 — Attach "L" Hooks to Handle
Spray Gun Hook
4.
Insert other "L" hook through hole just below
billboard on right side of handle (viewing from front of
unit). Hold hook in place and attach a plastic knob
from inside of unit (Figure 3).Tighten by hand.
7
Align Holes
Supports
Handle
Handle
Hose Hook
Publicidad
Capítulos
Tabla de contenido
