SUOMY GLIDER Instrucciones De Uso página 31

EN
USE AND MAINTENANCE
STRAP ADJUSTMENT AND POSITIONING - (see pictures 3/4)
After the helmet is properly worn, verify that the side of the strap is correctly positioned around the ears (pic. 3).
If this does not happen, slide the strap into the lateral adjustment system (fig 4) until the correct position is
reached. Then check that the chinstrap does not remain partially overlapping the ears (fig.3)
BACK SIZE MICROMETRIC ADJUSTER - (see pictures 5/6)
The back size adjuster is equipped with two regulation systems, one for the size and the other for the correct
height positioning.
Position the adjuster so that it lies on the occipital lobe. In case this does not occur use the height adjusters
located inside the helmet, and slide the adjuster upwards or downwards (pic. 5).
Then adjust the size using the adjustment wheel (pic. 6).
Turn the wheel clockwise to tighten or counter clockwise to decrease the tightening. Do this by using two fingers
as indicated in pic. 6.
WARNING: The adjustment of the system must ensure a good locking of the helmet on the head without
discomfort.