Hanger; Reverse Button - Makita DUR364L Manual De Instrucciones

NOTE:
The tool is automatically turned off after the tool is
•
left one minute without any operations.
Speed adjusting
1
015382
You can adjust the tool speed by tapping the main
power button.
Each time you tap the main power button,
indicator lights up. is for high speed and
Reverse button for debris removal
WARNING:
Switch off the tool and remove the battery cartridge
•
before you remove entangled weeds or debris which
the reverse rotation function can not remove. Failure
to switch off and remove the battery cartridge may result
in serious personal injury from accidental start-up.
015383
This tool has a reverse button to change the direction of
rotation. It is only for removing weeds and debris
entangled in the tool.
To reverse the rotation, tap the reverse button and pull
the trigger when the tool's head is stopped. The power
lamp starts blinking, and the tool's head rotates in
reverse direction when you pull the switch trigger.
To return to regular rotation, release the trigger and wait
until the tool's head stops.
NOTE:
During the reverse rotation, the tool operates only for
•
a short period of time and then automatically stops.
Once the tool is stopped, the rotation returns to
•
regular direction when you start the tool again.
If you tap the reverse button while the tool's head
•
is still rotating, the tool comes to stop and to be
ready for reverse rotation.
1. Main power
button
indicator or
for low speed.

1. Reverse button

1
Nylon cutting head (optional accessory)
NOTICE:
The bump feed will not operate properly if the
•
head is not rotating.
1
015389
The nylon cutting head is a dual string trimmer head
provided with a bump & feed mechanism.
To cause the nylon cord to feed out, the cutting head
should be bumped against the ground while rotating.
NOTE:
If the nylon cord does not feed out while bumping the
head, rewind/replace the nylon cord by following the
procedures described under "Maintenance".
ASSEMBLY
WARNING:
Always be sure that the tool is switched off
•
and battery cartridge is removed before
carrying out any work on the tool. Failure to
switch off and remove the battery cartridge may
result in serious personal injury from accidental
start-up.
Never start the tool unless it is completely
•
assembled. Operation of the tool in a partially
assembled state may result in serious personal
injury from accidental start-up.
Installing the grip
2
3
4
015390
Fit the grip onto the pipe and tighten it with two hex
bolts. Make sure that the grip is located further than the

hanger.

9
1. Most effective
cutting area
1. Grip
1
2. Hex bolt
3. Cover
4. Clamp
5. Hanger
5