Chain Brake ® Mechanical Test - McCulloch EAGER BEAVER EB428 Manual Del Usuario

CAUTION
A new saw chain stretches, requiring adjustment after as
few as 5 cuts. This is normal with a new chain, and the
interval between future adjustments will lengthen quickly.
CAUTION
If saw chain is TOO LOOSE or TOO TIGHT, the sprocket,
bar, chain, and crankshaft bearings will wear more rapidly.
Study Figure 3-4B for information concerning correct cold
tension (A), correct warm tension (B), and as a guide for
when saw chain needs adjustment (C).
A
3-5. CHAIN BRAKE
Your chain saw is equipped with a CHAIN BRAKE
reduces possibility of injury due to kickback. The brake is
activated if pressure is applied against brake lever when,
as in the event of kickback, operator's hand strikes the
lever. When the brake is actuated, chain movement stops
abruptly.
WARNING
The purpose of the CHAIN BRAKE
bility of injury due to kickback; however, it cannot provide
the intended measure of protection if the saw is operated
carelessly.
Always test the CHAIN BRAKE
periodically while on the job.
3 - ASSEMBLY INSTRUCTIONS
B
C
3-4B
® MECHANICAL TEST
® is to reduce the possi-
® before using your saw and
To Test CHAIN BRAKE
1. The CHAIN BRAKE
move) when BRAKE LEVER IS PULLED BACK AND
LOCKED (Figure 3-5A).
2. The CHAIN BRAKE
when brake lever is in forward position. You should not
be able to move chain (Figure 3-5B).
NOTE: The brake lever should snap into both positions. If
strong resistance is felt, or lever does not move into either
position, do not use your saw. Take it immediately to an
Authorized Service Center for repair.
® that
9
® :
® is DISENGAGED (chain can
® is ENGAGED (chain is stopped)
3-5A
3-5B