nedis RDIN2000WT Guia De Inicio Rapido página 7

•
Ensure you have fully read and understood the
instructions in this document before you install
or use the product. Keep this document for
future reference.
•
Only use the product as described in this
document.
•
Do not use the product if a part is damaged or
defective. Replace a damaged or defective
product immediately.
•
Do not drop the product and avoid bumping.
•
This product may only be serviced by a qualified
technician for maintenance to reduce the risk of
electric shock.
•
Unplug the product from the power source and
other equipment if problems occur.
•
Only use the provided power cable.
•
Do not expose the product to water or moisture.
•
Do not use the product where splashing of water
might occur, e.g. bathroom, swimming pool or
close to a washbowl.
•
Do not use this product in a bathtub, shower, or
water-filled reservoir.
•
Observe the plus (+) and minus (–) marks on the
cell, battery and equipment and ensure correct
use.
•
Do not use any cell or battery that is not
designed for use with the product.
•
Seek medical advice immediately if a cell or a
battery has been swallowed.
•
Use only the cell or battery in the application for
which it was intended.
•
Battery usage by children should be supervised.
•
Do not mix cells of different manufacture,
capacity, size or type within a product.
•
Properly dispose of the empty battery.
•
When possible, remove the battery from the
product when not in use.
•
Protect the eyes against exposure to visible and/
or infrared radiation. Take adequate precautions
when exposed.
•
The product might cause interference with
nearby devices.
•
Do not use the product at locations where the
use of wireless devices is prohibited due to
potential interference with other electronic
devices, which may cause safety hazards.
•
Place the product on a stable and flat surface.
•
Do not open the product.
•
Do not use an extension cable.
•
Do not leave the product unattended when
switched on.
•
Keep the product out of reach from children.
•
Listening on high volume for a long time will
damage your hearing.
Place the battery
•
Place 2 size AAA batteries (not included) into
9
A
.
4
Make sure to match the (+) and (-) polarity
markings.
Connecting the product
1. Plug the power adapter A
7
input A
.
2. Plug the other end of A
4
Only use the provided power cable.
4
If you use the product for the first time, the
system will ask you to set language and network
configurations.
Controls on the radio (image B)
Display
1
P1, P2, P3
2
Speaker
3
Volume
4
control dial
Previous
5
button
On /
6
standby
button
7
q
into the power
q
into a power outlet.
Shows information and
settings.
Press to select a preset
station.
Press and hold to store a
current station as a preset
station.
Turn the dial to increase or
decrease the volume.
Press to switch the music
on or off.
Press to move left/upwards
on the display or return.
Press to enter or exit
standby mode.
Press to switch off the alarm.