Noxon VR360 Manual De Usuario página 13

Pág. 13
Battery charging:
1. Connect the male connector of the charger to the female connector of the battery.
90 mins = 80% charge (approximate time)
150 mins = 100% charge (approximate time)
2. Multiple batteries can be charged by connecting them in series and connecting the charger to one
of them.
Charging the wireless controller:
1. Connect the USB cable to the controller and to a USB charging port.
Check charge level:
1. Disconnect the battery from the charger.
2. Connect the battery to the VR360 Minicablecam.
3. Turn on the VR 360 Minicablecam and the hand control.
4. Check the EXT battery level on the hand control display.
Tips and Warnings:
1. You can leave the charger / power supply connected to the batteries without posing any risk or
deterioration of the battery due to overcharging.
2. Due to the dependence that exists between the two speed parameters, we can reach a situation of
mutual blocking when choosing the speeds, where the margin in which we can move the speeds is
very small. This situation is more likely with very short routes and low ramp percentages, and we can
get out of it by increasing the ramp.
Disclaimer:
Noxon is not responsible for damage caused by improper use or modifications made to the product.
English