Audio Settings; System Settings - Pioneer DEH-X5700HD Manual De Instrucciones

AUDIO settings

Menu Item
FADER*1
BALANCE
EQ SETTING
[SUPER BASS], [POWERFUL],
[NATURAL], [VOCAL], [CUSTOM1],
[CUSTOM2], [FLAT]
Select an equalizer band and
level for further customizing.
Equalizer band: [80HZ], [250HZ],
[800HZ], [2.5KHZ], [8KHZ]
Equalizer level: [+6] to [–6]
LOUDNESS
[OFF], [LOW], [MID], [HI]
SUB.W*2
[NOR], [REV], [OFF]
SUB.W CTRL*2*3
Cut-off frequency: [50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Output level: [–24] to [+6]
Slope level: [–12], [–24]
BASS BOOST
[0] to [+6]
HPF SETTING
Cut-off frequency: [OFF], [50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Slope level: [–12], [–24]
12
En
Description
Adjust the front and rear speaker balance.
Adjust the left and right speaker balance.
Select or customize the equalizer curve.
[CUSTOM1] can be set separately for each source.
However, each of the below combinations are set
to the same setting automatically.
• USB, iPod, PANDORA (iPhone), and APP
(iPhone)
[CUSTOM2] is a shared setting used for all
sources.
Compensate for clear sound at low volume.
Select the subwoofer phase.
Only frequencies lower than those in the
selected range are output from the subwoofer.
Select the bass boost level.
Only frequencies higher than the high-pass filter
(HPF) cutoff are output from the speakers.
Menu Item
SLA
[+4] to [–4]
*1 Not available when [SUB.W/SUB.W] is selected in [SP-P/O MODE] in the INITIAL settings (page 6).
*2 Not available when [REAR/REAR] is selected in [SP-P/O MODE] in the INITIAL settings (page 6).
*3 Not available when [OFF] is selected in [SUB.W].

SYSTEM settings

You can also access to these menus when the unit is turned off.
Menu Item
CLOCK SET
12H/24H
[12H], [24H]
INFO DISPLAY
AUX
[ON], [OFF]
Description
Adjust the volume level for each source except
FM.
Each of the below combinations are set to the
same setting automatically.
• USB, iPod, PANDORA (iPhone), and APP
(iPhone)
Description
Set the clock (page 6).
Select the time notation.
Display the item on the sub information display.
Select from "SPEANA, " "LEVEL METER, " "SOURCE, "
"CLOCK," and "OFF."
Set to [ON] when using an auxiliary device
connected to the unit.