Saneo A019-05KR2 Manual Del Usuario página 31

Installation of the window kit
- Open the window halfway and install the window kit as shown in the diagrams
below. The kit can be installed horizontally or vertically.
- The flat end of the drain pipe connections must be clipped into place.
- Do not twist or block the drain pipe.
- The length of the drain pipe is 280mm at most and can extend to 1500mm. Do
not use extension cords or other replacement hoses as this may cause malfunction.
The drain pipe must not be blocked, otherwise it may cause overheating.
Water drainage
1) When the air conditioner stops when the tank is full, turn it off and disconnect the
plug.
Caution - Please move the unit carefully so as not to spill the water into the water
tray at the bottom of the unit.
2) Place a container under the side water outlet behind the air conditioner.
3) Unscrew the drain cover and remove the water plug, the water will automatically
flow into the container.
MAINTENANCE
1. Before cleaning, unplug the unit.
2. Do not use chemicals to clean the unit.
3. Never clean the unit directly under water or any other liquid.
4. If the unit is damaged, please contact a competent repairer.
3. Air filter
- The filter must be cleaned every 2 weeks in order to remove dirt and
dust:
d. Open the air inlet grille and remove the filter.
e. Clean the filter with detergent in lukewarm water and leave it to dry.
f. Once the filter is dry, put it back into the grille.
4. Cleaning the outer part of the air conditioner