Control Panel; Sound Emitted By The Beertender - Krups BeerTender VB2158 Manual Del Usuario

English
Remove the tap cover by pulling it upward as shown on the drawing -
n
fig. 14.
Note: this cover can be removed for cleaning.
Take the tap of the BeerTender Keg "Compatible BeerTender" and fit it into
n
place.
Note: Do not try to actuate the tap of the BeerTender Keg by hand.
Position the beer tube as shown on drawing - fig. 15.
n
Put the tap cover back in place.
n
Note: the tap cover cannot be closed if the BeerTender Keg tap is not fitted
properly.
make sure the tap handle is positioned in the tapping mechanism before
n
the lid is closed.
make sure that the handle is positioned as shown on the drawing to avoid
n
damaging the beer tube - fig. 16.
Carefully close the appliance lid - fig. 17.
n

CoNTRoL PaNEL

Two LEDs on the top of the lid provide important indications:
n
Green oN LED on the left of the panel: when lit, it indicates that the
appliance is operating - fig. 18.
Green beer-temperature LED on the right side of the panel: when the
BeerTender Keg has reached the ideal temperature the LED switches on
and the appliance goes into "stand-by" cooling mode - fig. 19.
soUND EmITTED By ThE BEERTENDER aPPLIaNCE
The cooling function of the BeerTender produces sound.
n
The BeerTender features a cooling system which controls the temperature
n
of the BeerTender Keg. There are two cooling modes:
26
otice_krups_beertender.indd 26
1. stand-by cooling corresponds to the main operating conditions. In this
mode the cooling fan produces a barely audible noise;
2. active cooling is triggered when temperature inside the cooling chamber
is too high. as soon as the beer keg reaches the right temperature, the
appliance will switch back to stand-by cooling mode.
10/08/10 14:29:54