Aquaglide FULL DECK 15.0 Manual Del Propietário página 7

1. Locate a flat, dry area with access to outlet for electrical pump. The best setup position
will also make launching easy. Never drag product as damage may occur.
2. Unfold product completely and locate Main Valve [1]. To help future storage, closely note
original folding & packaging method. Remove valve cap and confirm valve is in inflate (1-way
airflow) position (see HR Valve Operation Graphic).
3. Insert air pump hose with proper valve fitting into Main Valve [1], lock into place. Use
pump to inflate Main Valve [1] to Working Pressure as shown in Chart 1. Check for proper
pressure using gauge (manometer). Replace valve cap.
4. If using this product alone, proceed to next step for launching instructions. If this item will
be attached to others, follow steps below to prepare connections prior to launching. When
connecting multiple items together follow guidelines carefully. Use only Two-Step Vario-lock
cinch straps and Aquaglide connecting rings. See D.
a. Full Deck 15.0 is a 'connector' item. Straps should first be attached to 'Connector'
items (example: Swimstep, Splashmat, Speedway, Breezeway or Deck) only where a
connection is needed. Your configuration determines how many straps are needed; you
may use all, some, or none of the straps supplied.
b. 'Connector' items generally go between or attach to feature items. Connectors should
not be attached to other connectors.
c. Use all available rings to make connection. Standard connections use 5 rings. Some
items use 3 or occasionally 7 rings/ straps. Full Deck 15.0 has 5-ring sets on 2 ends.
d. After launch instructions (below) float 'Connector' with necessary straps attached into
desired position. Note: a matching set of connecting rings is required on feature item.
e. Attach center strap to center ring on feature item. Connect loosely, then work outward
until all straps are connected.
f. Dive beneath to tighten all straps securely. Dive mask and several attempts may be
required. Make sure connection is tight and there is NO GAP between items. Failure to
connect items properly may result in injury or death.
D
5. To launch product, lift completely and place in water. Large items may require many extra
people to accomplish this. Never drag product as damage may occur. Confirm that suitable
anchor(s) and mooring lines are in place before launching this item (see Anchoring).
7
3
1
2
0mm
5X
www.aquaglide.com