Items Supplied; Technical Data - Robust RB-RH 1600 Manual De Instrucciones Original

Anleitung_RB_RH_1600_SPK7__ 10.07.14 09:39 Seite 15
minimum.
Always keep the power cable away from where
n
you want to drill.
Keep the machine out of children's reach.
n
Always hold the machine with two hands when it
n
is running and make sure of your footing.
Make sure that the switch on the machine is set
n
to the correct position for the work you want to
perform before you put the machine into opera-
tion. If the switch is not in the correct position you
risk suffering bodily injury when the machine
starts to run.
Do not lose these safety instructions
2. Layout and items supplied
(Fig. 1)
2.1 Layout
1. Dust guard
2. Locking sleeve
3. Rotary switch for rotation stop facility
4. ON/OFF switch
5. Rotary switch for hammer stop facility
6. Additional handle
7. Depth stop
8. Handle

2.2 Items supplied

Open the packaging and take out the equipment
n
with care.
Remove the packaging material and any
n
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
n
Inspect the equipment and accessories for
n
transport damage.
If possible, please keep the packaging until the
n
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts. There is a danger of
swallowing or suffocating!
Hammer drill
n
Additional handle
n
Depth stop
n
Dust collection device
n
Original operating instructions
n
3. Proper use
The tool is designed for drilling with hammer action in
concrete, rock and brick, as well as for chiseling
work, always using the respective correct drill or
chisel bit.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Mains voltage: 230 V ~ 50 Hz
Power input:
Idling speed:
Blow rate:
Drilling capacity in concrete/stone (max.):
Protection class:
Weight:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level 92.4 dB(A)
pA
K uncertainty
pA
L sound power level 103.4 dB(A)
WA
K uncertainty
WA
The hammer drill is not designed for outdoors use as
specified I Article 3 of Directive
2000/14/EC_2005/88/EC.
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
GB
1600 W
800 rpm
3900 rpm
32 mm
II /
5.6 kg
3 dB
3 dB
15